Messages in this thread | | | Date | Tue, 28 May 2013 08:36:16 +0200 | Subject | Re: [PATCH v2 5/9] pinconf-generic: add BIAS_BUS_HOLD pinconf | From | Linus Walleij <> |
| |
On Fri, May 24, 2013 at 6:21 PM, James Hogan <james.hogan@imgtec.com> wrote:
> Add a new PIN_CONFIG_BIAS_BUS_HOLD pin configuration for a bus holder > pin mode (also known as bus keeper, or repeater). This is a weak latch > which drives the last value on a tristate bus. Another device on the bus > can drive the bus high or low before going tristate to change the value > driven by the pin. > > Signed-off-by: James Hogan <james.hogan@imgtec.com> > Cc: Linus Walleij <linus.walleij@linaro.org> > --- > Changes in v2: > - add BIAS_BUS_HOLD generic pinconf (patch 5)
This is fine: Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Yours, Linus Walleij
| |