lkml.org 
[lkml]   [2012]   [Sep]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
Subject[PATCH] Powerpc 8xx CPM_UART too many interrupts
Setting the fifo to only 1 byte generates one interrupt every 1ms at 9600 bauds.
This is too much. This patch reduces the threshold to speeds below 2400 bauds
like in the 8250 UART driver.

Signed-off-by: Christophe Leroy <christophe.leroy@c-s.fr>

--- linux-3.5-vanilla/drivers/tty/serial/cpm_uart/cpm_uart_core.c 2012-07-21 22:58:29.000000000 +0200
+++ linux-3.5/drivers/tty/serial/cpm_uart/cpm_uart_core.c 2012-08-09 17:38:37.000000000 +0200
@@ -71,7 +71,7 @@

/**************************************************************/

-#define HW_BUF_SPD_THRESHOLD 9600
+#define HW_BUF_SPD_THRESHOLD 2400

/*
* Check, if transmit buffers are processed
@@ -505,7 +505,7 @@
pr_debug("CPM uart[%d]:set_termios\n", port->line);

baud = uart_get_baud_rate(port, termios, old, 0, port->uartclk / 16);
- if (baud <= HW_BUF_SPD_THRESHOLD ||
+ if (baud < HW_BUF_SPD_THRESHOLD ||
(pinfo->port.state && pinfo->port.state->port.tty->low_latency))
pinfo->rx_fifosize = 1;
else

\
 
 \ /
  Last update: 2012-09-24 09:01    [W:0.029 / U:0.116 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site