Messages in this thread | | | Date | Mon, 2 Apr 2012 22:53:22 +0200 | From | Borislav Petkov <> | Subject | Re: CONFIG_RTLWIFI_DEBUG default y |
| |
On Mon, Apr 02, 2012 at 03:46:54PM -0500, Larry Finger wrote: > Users will see nothing more than before! > > Before CONFIG_RTLWIFI_DEBUG was allowed to be set, the driver always > compiled in the debug code, but only those messages with the > DBG_EMERG code were actually output. With the parameter set to Y, > nothing changed. If the module is loaded with the "debug=X" option, > where X is greater than 0, then other messages will be seen. That > dynamic setting of the level is enough. > > The only change when the configuration parameter is set to N is that > the entire debug setup compiles away. The driver is a lot smaller, > but there is no debugging.
Yes, yes, I knew there should be some sane default there, rtlpriv->dbg.global_debuglevel remains 0 which is DBG_EMERG. I stand corrected, thanks.
-- Regards/Gruss, Boris.
| |