lkml.org 
[lkml]   [2012]   [Nov]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
Subjectpossible regression in kernel 3.6: system hangs during nightly tape backup
For the 4th time now after switching to kernel 3.6, my system became
unresponsive during the nightly Bacula backup run. It looks as if
all disk accesses are suddenly blocked:
- Desktop apps stop responding one after another, starting with
Firefox followed by other "heavy" apps, while Konsole windows
continue being usable for a while.
- "top" shows the load average steadily increasing with no process
actually consuming relevant quantities of CPU.
- I can do "dmesg > /root/dmesg.out" followed by "less /root/dmesg.out"
in a Konsole window just fine, but after the inevitable hard reset
the file /root/dmesg.out isn't there.
- The "sync" command hangs indefinitely.
- The "shutdown" command and ctrl/alt/Del emit "system going down"
broadcast messages but never get anywhere.
- Killing processes manually works for some (bacula-sd even ejects
the tape before exiting) but most remain in state D or Z.
- Eventually, all text consoles are blocked and a hardware reset is
the only remaining option.
- After the reboot, a Bacula spool file is left behind in
/var/spool/bacula, proof that the hang happened during the backup.

This does not happen during every backup run, but frequently enough
to be annoying. (About once per week.) It never happened with kernel
3.5. For comparison went back to kernel 3.5.7 for a week and it
never happened during that time. Last night I booted 3.6.7 and the
very next backup caused the hang again. The last kernel message that
made it to the syslog on disk was

Nov 19 23:05:04 xenon kernel: [73877.128546] st0: Block limits 256 -
524288 bytes.

triggered by the start of the backup. In dmesg the next message was

[74401.249091] INFO: task flush-253:2:1320 blocked for more than 120
seconds.

followed by a backtrace. I have photos of the remaining dmesg output
which I'll try to upload somewhere accessible tomorrow.

Hardware configuration:
Intel Pentium D, Intel DQ965GF mainboard, 6 GB RAM
onboard S-ATA controller driving two 500 GB S-ATA disks
and a Pioneer DVR-216D DVD-RW drive
Adaptec 29160B Ultra160 SCSI adapter driving a
Tandberg TS400 LTO-2 tape drive

Disk configuration: md RAID1, LVM, ext3 and ext4 volumes

Software: Opensuse 11.4 64 bit, vanilla kernel 3.5.7 and 3.6.7,
Bacula 5.2.12

HTH
T.

--
Tilman Schmidt E-Mail: tilman@imap.cc
Bonn, Germany
Diese Nachricht besteht zu 100% aus wiederverwerteten Bits.
Ungeöffnet mindestens haltbar bis: (siehe Rückseite)

[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2012-11-20 02:01    [W:0.077 / U:0.252 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site