lkml.org 
[lkml]   [2011]   [Jul]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 10/18] dmaengine/amba-pl08x: Get rid of pl08x_pre_boundary()
On Fri, Jul 29, 2011 at 04:19:20PM +0530, Viresh Kumar wrote:
> Pl080 Manual says: "Bursts do not cross the 1KB address boundary"
>
> We can program the controller to cross 1 KB boundary on a burst and controller
> can take care of this boundary condition by itself.
>
> Following is the discussion with ARM Technical Support Guys (David):
> [Viresh] Manual says: "Bursts do not cross the 1KB address boundary"
>
> What does that actually mean? As, Maximum size transferable with a single LLI is
> 4095 * 4 =16380 ~ 16KB. So, if we don't have src/dest address aligned to burst
> size, we can't use this big of an LLI.
>
> [David] There is a difference between bursts describing the total data
> transferred by the DMA controller and AHB bursts. Bursts described by the
> programmable parameters in the PL080 have no direct connection with the bursts
> that are seen on the AHB bus.
>
> The statement that "Bursts do not cross the 1KB address boundary" in the TRM is
> referring to AHB bursts, where this limitation is a requirement of the AHB spec.
> You can still issue bursts within the PL080 that are in excess o f 1KB. The
> PL080 will make sure that its bursts are broken down into legal AHB bursts which
> will be formatted to ensure that no AHB burst crosses a 1KB boundary.
>
> Based on above discussion, this patch removes all code related to 1 KB boundary
> as we are not required to handle this in driver.

Good. I'm glad someone's finally getting to the bottom of what's
actually required and what isn't... This driver has been a mess for
quite a long time and is in desperate need of these kinds of cleanups.


\
 
 \ /
  Last update: 2011-07-29 13:07    [W:0.450 / U:0.156 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site