lkml.org 
[lkml]   [2009]   [Aug]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
Subject[PATCH] adjust Hyper-V Kconfig
Hyper-V sub-components' options should all depend on the base option.

The default of these sub-component options is also more reasonably set
to that of the base option (since it makes little sense to enable the
base option without the sub-component ones).

Signed-off-by: Jan Beulich <jbeulich@novell.com>

--- linux-next/drivers/staging/hv/Kconfig
+++ linux-next/drivers/staging/hv/Kconfig
@@ -6,23 +6,27 @@
Select this option to run Linux as a Hyper-V client operating
system.

+if HYPERV
+
config HYPERV_STORAGE
tristate "Microsoft Hyper-V virtual storage driver"
- depends on SCSI && m
- default n
+ depends on SCSI
+ default HYPERV
help
Select this option to enable the Hyper-V virtual storage driver.

config HYPERV_BLOCK
tristate "Microsoft Hyper-V virtual block driver"
- depends on BLOCK && SCSI && m
- default n
+ depends on BLOCK && SCSI
+ default HYPERV
help
Select this option to enable the Hyper-V virtual block driver.

config HYPERV_NET
tristate "Microsoft Hyper-V virtual network driver"
- depends on NET && m
- default n
+ depends on NET
+ default HYPERV
help
Select this option to enable the Hyper-V virtual network driver.
+
+endif




\
 
 \ /
  Last update: 2009-08-17 13:57    [W:0.045 / U:0.976 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site