[lkml]   [2007]   [Mar]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
    Subject-rc5: e1000 resume weirdness

    hm, on a T60, after suspend/resume, i get an e1000 timeout:

    e1000: eth0: e1000_watchdog: NIC Link is Up 1000 Mbps Full Duplex, Flow Control: RX/TX
    e1000: eth0: e1000_clean_tx_irq: Detected Tx Unit Hang
    Tx Queue <0>
    TDH <ec>
    TDT <ec>
    next_to_use <ec>
    next_to_clean <82>
    time_stamp <fffcc3db>
    next_to_watch <82>
    jiffies <fffd5da0>
    next_to_watch.status <1>

    it works fine after that reset. The e1000 driver didnt do this before
    after resume the network was always available immediately. So this
    appears to be a relatively new regression (post-rc3 or so). high-res
    timers was disabled.

    To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
    the body of a message to
    More majordomo info at
    Please read the FAQ at

     \ /
      Last update: 2007-03-26 12:15    [W:2.240 / U:0.348 seconds]
    ©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site