lkml.org 
[lkml]   [2006]   [Jun]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH] hptiop: HighPoint RocketRAID 3xxx controller driver
From
Date
On Sun, 2006-06-11 at 19:18 +0800, HighPoint Linux Team wrote:
> dprintk("hptiop_queuecmd : no free req\n");
> - scp->result = DID_BUS_BUSY << 16;
> + scp->result = SCSI_MLQUEUE_HOST_BUSY;
> goto cmd_done;

As jeff said, this needs to become a return SCSI_MLQUEUE_HOST_BUSY.

> On Sunday 11 June 2006 05:07 pm, HighPoint Linux Team wrote:
> >>
> >> host->can_queue = le32_to_cpu(iop_config.max_requests);
> >> host->cmd_per_lun = le32_to_cpu(iop_config.max_requests);
> >>
> >> You might want to think about adjusting this. For the single LUN case,
> >> it's fine. For the multi-lun case it may allow commands to a single LUN
> >> to starve everything else.
> >
> >There will be no multi-lun support for the controller so this is not
> >an issue.
>
> Sorry, a mistake. Multi-lun is supported.
> Should host->can_queue be set to (cmd_per_lun * max_lun) ?

It depends on how the controller behaves. Setting can_queue and
cmd_per_lun tends to work for most SCSI controllers because the actual
scsi devices have queue depths << this number. If your controller will
behave like this (i.e. will not allow the internal queue for a single
lun to fill up to this depth) then you can keep this setting (although,
again, since this is probably fixed by the firmware, you want to set
cmd_per_lun to this value to avoid excessive QUEUE_FULL returns). If
the controller will happily load all the available slots up for a single
lun, then you might want to think about reducing cmd_per_lun to some
fraction of can_queue (you could even set it to can_queue - 2 like the
3ware controller).

Most of the other actual raid controllers seem to have much smaller
per-lun queues, so they mainly set smaller, fixed size values for
cmd_per_lun.

James


-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2006-06-11 17:03    [W:1.449 / U:0.112 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site