lkml.org 
[lkml]   [2005]   [Nov]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
Subject2.6.15-rc1: IDE: fix potential data corruption with SL82C105 interfaces
We must _never_ _ever_ on pain of death enable IDE DMA on SL82C105
chipsets where the southbridge revision is <= 5, otherwise data
corruption will occur.

Strangely this used to work, but something has changed in the upper
echelons of the IDE layer to break the hosts decision to deny DMA.
Let's make it crystal clear to the IDE layer that we know best.

Note: due to the urgency of this fix, I will be applying this to the
ARM tree. Any comments/criticisms can be dealt with further patches.


diff -up -x BitKeeper -x ChangeSet -x SCCS -x _xlk -x *.orig -x *.rej -x .git linus/drivers/ide/pci/sl82c105.c linux/drivers/ide/pci/sl82c105.c
--- linus/drivers/ide/pci/sl82c105.c Sun Nov 6 22:16:04 2005
+++ linux/drivers/ide/pci/sl82c105.c Sat Nov 12 16:50:20 2005
@@ -399,34 +399,6 @@ static unsigned int __devinit init_chips
return dev->irq;
}

-static void __devinit init_dma_sl82c105(ide_hwif_t *hwif, unsigned long dma_base)
-{
- unsigned int rev;
- u8 dma_state;
-
- DBG(("init_dma_sl82c105(hwif: ide%d, dma_base: 0x%08x)\n", hwif->index, dma_base));
-
- hwif->autodma = 0;
-
- if (!dma_base)
- return;
-
- dma_state = hwif->INB(dma_base + 2);
- rev = sl82c105_bridge_revision(hwif->pci_dev);
- if (rev <= 5) {
- printk(" %s: Winbond 553 bridge revision %d, BM-DMA disabled\n",
- hwif->name, rev);
- dma_state &= ~0x60;
- } else {
- dma_state |= 0x60;
- if (!noautodma)
- hwif->autodma = 1;
- }
- hwif->OUTB(dma_state, dma_base + 2);
-
- ide_setup_dma(hwif, dma_base, 8);
-}
-
/*
* Initialise the chip
*/
@@ -434,6 +406,8 @@ static void __devinit init_dma_sl82c105(
static void __devinit init_hwif_sl82c105(ide_hwif_t *hwif)
{
struct pci_dev *dev = hwif->pci_dev;
+ unsigned int rev;
+ u8 dma_state;
u32 val;

DBG(("init_hwif_sl82c105(hwif: ide%d)\n", hwif->index));
@@ -455,33 +429,51 @@ static void __devinit init_hwif_sl82c105
pci_read_config_dword(dev, 0x40, &val);
*((u32 *)&hwif->hwif_data) = val;

+ hwif->atapi_dma = 0;
+ hwif->mwdma_mask = 0;
+ hwif->swdma_mask = 0;
+ hwif->autodma = 0;
+
if (!hwif->dma_base)
return;

- hwif->atapi_dma = 1;
- hwif->mwdma_mask = 0x07;
- hwif->swdma_mask = 0x07;
-
+ dma_state = hwif->INB(hwif->dma_base + 2) & ~0x60;
+ rev = sl82c105_bridge_revision(hwif->pci_dev);
+ if (rev <= 5) {
+ /*
+ * Never ever EVER under any circumstances enable
+ * DMA when the bridge is this old.
+ */
+ printk(" %s: Winbond 553 bridge revision %d, BM-DMA disabled\n",
+ hwif->name, rev);
+ } else {
#ifdef CONFIG_BLK_DEV_IDEDMA
- hwif->ide_dma_check = &sl82c105_check_drive;
- hwif->ide_dma_on = &sl82c105_ide_dma_on;
- hwif->ide_dma_off_quietly = &sl82c105_ide_dma_off_quietly;
- hwif->ide_dma_lostirq = &sl82c105_ide_dma_lost_irq;
- hwif->dma_start = &sl82c105_ide_dma_start;
- hwif->ide_dma_timeout = &sl82c105_ide_dma_timeout;
-
- if (!noautodma)
- hwif->autodma = 1;
- hwif->drives[0].autodma = hwif->autodma;
- hwif->drives[1].autodma = hwif->autodma;
+ dma_state |= 0x60;
+
+ hwif->atapi_dma = 1;
+ hwif->mwdma_mask = 0x07;
+ hwif->swdma_mask = 0x07;
+
+ hwif->ide_dma_check = &sl82c105_check_drive;
+ hwif->ide_dma_on = &sl82c105_ide_dma_on;
+ hwif->ide_dma_off_quietly = &sl82c105_ide_dma_off_quietly;
+ hwif->ide_dma_lostirq = &sl82c105_ide_dma_lost_irq;
+ hwif->dma_start = &sl82c105_ide_dma_start;
+ hwif->ide_dma_timeout = &sl82c105_ide_dma_timeout;
+
+ if (!noautodma)
+ hwif->autodma = 1;
+ hwif->drives[0].autodma = hwif->autodma;
+ hwif->drives[1].autodma = hwif->autodma;
#endif /* CONFIG_BLK_DEV_IDEDMA */
+ }
+ hwif->OUTB(dma_state, hwif->dma_base + 2);
}

static ide_pci_device_t sl82c105_chipset __devinitdata = {
.name = "W82C105",
.init_chipset = init_chipset_sl82c105,
.init_hwif = init_hwif_sl82c105,
- .init_dma = init_dma_sl82c105,
.channels = 2,
.autodma = NOAUTODMA,
.enablebits = {{0x40,0x01,0x01}, {0x40,0x10,0x10}},

--
Russell King
Linux kernel 2.6 ARM Linux - http://www.arm.linux.org.uk/
maintainer of: 2.6 Serial core
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2005-11-12 17:58    [W:0.067 / U:0.516 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site