lkml.org 
[lkml]   [2002]   [May]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectIDE hotswap
I would like to implement real hotswapping support with IDE drives in the
following setup:

Asus A7V motherboard (has 2 standard IDE bus, and 2 additional bus)
cheap/standard hotswap IDE hardware

00:04.1 IDE interface: VIA Technologies, Inc. VT82C586 IDE [Apollo] (rev 10)
00:11.0 Unknown mass storage controller: Promise Technology, Inc.: Unknown device 0d30 (rev 02)

Simply removing and replacing the disk drive will cause hangs in normal
operation.

I have noticed, by creating a simple boot floppy with IDE modules
(ide_mod, ide_disk, ide_probe_mod), that if you remove ide_probe_mod,
replace the disk, and reinsert ide_probe_mod, the disk is detected
correctly (geometry, size, etc).

My questions:

- assuming one-disk-per-bus (ie 4 disks in the above IDE+promise
configuration), is it at all feasible ? (ie IDE masters only)

- should I expect the IDE chips to hardware-fail after a few
inserts/removes ?

- would modifying drivers/ide/ide_probe.c to add a new function
drop_bus(bus_id), scan_bus(bus_id) be a good idea, along with
a /proc interface from ide_probe.c or another to be developped
module ?

- is there already work in progress in the topic ? or a simpler
way to do the above ?

The initial case is to assume that inserting/removing must be done in a
software-controlled way.

The next step will be to see if the IDE subsystem can detect a failing
drive / removed drive without warning. Reinsertion could be done by
polling every 30 seconds or manual user intervention.

Thank you for any comments.


-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2005-03-22 13:26    [W:0.045 / U:0.532 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site