Messages in this thread | | | From | Oleg Drokin <> | Subject | 2.1.121 reboots at boot | Date | Sat, 12 Sep 1998 20:47:55 +0400 (MSD) |
| |
Hello!
I am having boot problem with 2.1.121 When I try use LILO (20 from Slackware 3.5) to boot up linux kernel 2.1.121, I just getting reboot right after 'Loading linux.......' in 6-8 tries from 10, some times I getting hungs instead of reboots One or two times It is complained about 'crc error'. However if I dd kernel to floppy or try to load it with LoadLin from DOS, all is fine. I even tried to copy kernel at another location on ext2fs to ensure that there is not corrupted disk area. No luck. Kernels since 2.1.85 to 2.1.120 behaves well, 2.0.X is good too. If I boot 2.1.121, ten probability of loading next time before power cycle is increased until I load another kernel. Am I doing something wrong, or what can it be? I use just plain Pentium 166 and mobo with plain Intel VX chipset. 16M of RAM. All kernels compiled with GCC 2.7.2.3. Here is my /proc/cpuinfo, kernel config and output of kernel at boot time. processor : 0 vendor_id : GenuineIntel cpu family : 5 model : 2 model name : Pentium 75+ stepping : 12 fdiv_bug : no hlt_bug : no sep_bug : no f00f_bug : yes fpu : yes fpu_exception : yes cpuid level : 1 wp : yes flags : fpu vme de pse tsc msr mce cx8 bogomips : 66.76
Linux version 2.1.121 (root@mordor) (gcc version 2.7.2.3) #7 Fri Sep 11 23:53:48 MSD 1998 Console: colour VGA+ 80x25 Calibrating delay loop... 66.76 BogoMIPS Memory: 14932k/16384k available (644k kernel code, 400k reserved, 376k data, 32k init) CPU: Intel Pentium 75+ stepping 0c Checking 386/387 coupling... OK, FPU using exception 16 error reporting. Checking 'hlt' instruction... OK. Intel Pentium with F0 0F bug - workaround enabled. POSIX conformance testing by UNIFIX PCI: PCI BIOS revision 2.10 entry at 0xfb280 PCI: Using configuration type 1 PCI: Probing PCI hardware Swansea University Computer Society NET3.039 for Linux 2.1 NET3: Unix domain sockets 0.16 for Linux NET3.038. Swansea University Computer Society TCP/IP for NET3.037 IP Protocols: ICMP, UDP, TCP Starting kswapd v 1.5 Serial driver version 4.26 with no serial options enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A Real Time Clock Driver v1.09 PIIX3: IDE controller on PCI bus 00 dev 39 PIIX3: not 100% native mode: will probe irqs later ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:pio, hdb:pio ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:pio, hdd:pio hda: QUANTUM FIREBALL_TM1280A, ATA DISK drive hdb: ST31722A, ATA DISK drive hdd: MATSHITA CR-583, ATAPI CDROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: QUANTUM FIREBALL_TM1280A, 1222MB w/76kB Cache, CHS=621/64/63, DMA hdb: ST31722A, 1625MB w/0kB Cache, CHS=825/64/63, DMA Partition check: hda: hda1 hda2 < hda5 hda6 > hda3 hdb: hdb1 hdb2 hdb3 < hdb5 > hdb4 VFS: Mounted root (ext2 filesystem) readonly. Freeing unused kernel memory: 32k freed
CONFIG_EXPERIMENTAL=y CONFIG_M586=y CONFIG_MODULES=y CONFIG_MODVERSIONS=y CONFIG_KMOD=y CONFIG_NET=y CONFIG_PCI=y CONFIG_PCI_BIOS=y CONFIG_PCI_DIRECT=y CONFIG_PCI_QUIRKS=y CONFIG_PCI_OPTIMIZE=y CONFIG_PCI_OLD_PROC=y CONFIG_SYSVIPC=y CONFIG_SYSCTL=y CONFIG_BINFMT_AOUT=m CONFIG_BINFMT_ELF=y CONFIG_BINFMT_MISC=m CONFIG_BLK_DEV_FD=m CONFIG_BLK_DEV_IDE=y CONFIG_BLK_DEV_IDEDISK=y CONFIG_BLK_DEV_IDECD=m CONFIG_BLK_DEV_IDEPCI=y CONFIG_BLK_DEV_IDEDMA=y CONFIG_IDEDMA_AUTO=y CONFIG_BLK_DEV_LOOP=m CONFIG_PARIDE_PARPORT=y CONFIG_PACKET=y CONFIG_UNIX=y CONFIG_INET=y CONFIG_IP_NOSR=y CONFIG_NETDEVICES=y CONFIG_DUMMY=m CONFIG_NET_ETHERNET=y CONFIG_NET_ISA=y CONFIG_NE2000=m CONFIG_PPP=m CONFIG_SLIP=m CONFIG_SLIP_COMPRESSED=y CONFIG_SLIP_SMART=y CONFIG_VT=y CONFIG_VT_CONSOLE=y CONFIG_SERIAL=y CONFIG_RTC=y CONFIG_NVRAM=m CONFIG_EXT2_FS=y CONFIG_ISO9660_FS=m CONFIG_JOLIET=y CONFIG_FAT_FS=y CONFIG_MSDOS_FS=m CONFIG_VFAT_FS=y CONFIG_PROC_FS=y CONFIG_NFS_FS=m CONFIG_NFSD=m CONFIG_SUNRPC=m CONFIG_LOCKD=m CONFIG_NLS=y CONFIG_NLS_CODEPAGE_437=m CONFIG_NLS_CODEPAGE_866=m CONFIG_NLS_ISO8859_1=m CONFIG_NLS_KOI8_R=m CONFIG_VGA_CONSOLE=y CONFIG_SOUND=m CONFIG_SOUND_OSS=m CONFIG_SOUND_SB=m CONFIG_SOUND_ADLIB=m CONFIG_SOUND_SOFTOSS=m CONFIG_SOUND_YM3812=m CONFIG_MAGIC_SYSRQ=y
Bye, Oleg -- [RAVE *SUCKS* TEAM] [Team $Ui(iDE] [Trans-M Must Die!] [Sepultura Fans Team] [Tolkien forever team]
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/faq.html
| |