On Sun, Mar 08, 2026 at 04:52:43PM +0100, Cristian Cozzolino via B4 Relay wrote:
> From: Cristian Cozzolino <cristian_ci@protonmail.com>
> 
> Add the description for the display panel found on this phone.
> And with this done we can also enable the GPU and set the zap shader
> firmware path.
> 
> Signed-off-by: Cristian Cozzolino <cristian_ci@protonmail.com>
> ---
>  .../arm64/boot/dts/qcom/msm8953-flipkart-rimob.dts | 80 ++++++++++++++++++++++
>  1 file changed, 80 insertions(+)
> 
> +
> +&mdss_dsi0 {
> +	vdda-supply = <&pm8953_s3>;
> +	vddio-supply = <&pm8953_l6>;
> +
> +	pinctrl-0 = <&mdss_default>;
> +	pinctrl-1 = <&mdss_sleep>;
> +	pinctrl-names = "default", "sleep";

It might be better to move pinctrl nodes to the panel device, because
they control the panel reset pin (rather than some kind if DSI-related
pin).

Other than that LGTM.

> +
> +	status = "okay";
> +
> +	panel: panel@0 {
> +		compatible = "novatek,nt35532";
> +		reg = <0>;
> +
> +		backlight = <&pmi8950_wled>;
> +		reset-gpios = <&tlmm 61 GPIO_ACTIVE_LOW>;
> +		vsp-supply = <&lab>;
> +		vsn-supply = <&ibb>;
> +
> +		port {
> +			panel_in: endpoint {
> +				remote-endpoint = <&mdss_dsi0_out>;
> +			};
> +		};
> +	};
> +};
> +

-- 
With best wishes
Dmitry