On Tuesday, March 10th, 2026 at 12:28, Konrad Dybcio <konrad.dybcio@oss.qualcomm.com> wrote:

> On 3/8/26 4:01 PM, Dmitry Baryshkov wrote:
> > On Sun, Mar 08, 2026 at 04:52:43PM +0100, Cristian Cozzolino via B4 Relay wrote:
> >> From: Cristian Cozzolino <cristian_ci@protonmail.com>
> >>
> >> Add the description for the display panel found on this phone.
> >> And with this done we can also enable the GPU and set the zap shader
> >> firmware path.
> >>
> >> Signed-off-by: Cristian Cozzolino <cristian_ci@protonmail.com>
> >> ---
> >>  .../arm64/boot/dts/qcom/msm8953-flipkart-rimob.dts | 80 ++++++++++++++++++++++
> >>  1 file changed, 80 insertions(+)
> >>
> >> +
> >> +&mdss_dsi0 {
> >> +	vdda-supply = <&pm8953_s3>;
> >> +	vddio-supply = <&pm8953_l6>;
> >> +
> >> +	pinctrl-0 = <&mdss_default>;
> >> +	pinctrl-1 = <&mdss_sleep>;
> >> +	pinctrl-names = "default", "sleep";
> >
> > It might be better to move pinctrl nodes to the panel device, because
> > they control the panel reset pin (rather than some kind if DSI-related
> > pin).
> 
> +1, perhaps let's rename that pin to panel_reset while at it

So, something like (plus related renaming in tlmm node):

	panel: panel@0 {
		compatible = "novatek,nt35532";
		reg = <0>;

		backlight = <&pmi8950_wled>;
		reset-gpios = <&tlmm 61 GPIO_ACTIVE_LOW>;
		vsp-supply = <&lab>;
		vsn-supply = <&ibb>;

		pinctrl-0 = <&panel_default>;
		pinctrl-1 = <&panel_reset>;
		pinctrl-names = "default", "reset";

		port {
			panel_in: endpoint {
				remote-endpoint = <&mdss_dsi0_out>;
			};
		};
	};
 
this?

> Konrad
> 

Regards