lkml.org 
[lkml]   [2024]   [Mar]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    Date
    SubjectRe: [PATCH v4] arm64: dts: qcom: qcm6490-idp: enable PMIC Volume and Power buttons
    From


    On 3/6/2024 3:56 PM, Dmitry Baryshkov wrote:
    > On Wed, 6 Mar 2024 at 05:02, hui liu <quic_huliu@quicinc.com> wrote:
    >>
    >>
    >>
    >> On 3/6/2024 5:20 AM, Konrad Dybcio wrote:
    >>>
    >>>
    >>> On 3/4/24 08:09, Hui Liu via B4 Relay wrote:
    >>>> From: Hui Liu <quic_huliu@quicinc.com>
    >>>>
    >>>> The Volume Down & Power buttons are controlled by the PMIC via
    >>>> the PON hardware, and the Volume Up is connected to a PMIC gpio.
    >>>>
    >>>> Enable the necessary hardware and setup the GPIO state for the
    >>>> Volume Up gpio key.
    >>>>
    >>>> Signed-off-by: Hui Liu <quic_huliu@quicinc.com>
    >>>> ---
    >>>
    >>> [...]
    >>>
    >>>
    >>>> +&pmk8350_pon {
    >>>> + status = "okay";
    >>>> +};
    >>>
    >>> This device is already enabled
    >> Hi Konrad,
    >>
    >> The status is not set in pmk8350.dtsi, so I thought we should set it for
    >> "okay" manually. Do you think so?
    >
    > What is the default device status if there is no status property?
    The default status is okay.
    OK, I will update it, remove the status configuration.

    Thanks,
    Hui
    >
    >

    \
     
     \ /
      Last update: 2024-05-27 15:43    [W:7.476 / U:0.020 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site