lkml.org 
[lkml]   [2023]   [Aug]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH 5/9] arm64: dts: qcom: sa8775p-ride: move the reset-gpios property of the PHY
On Tue, Aug 8, 2023 at 12:27 AM Andrew Halaney <ahalaney@redhat.com> wrote:
>
> On Mon, Aug 07, 2023 at 11:51:40PM +0200, Andrew Lunn wrote:
> > > > I have proposed a solution for this problem in 2020 but it never got
> > > > upstream. Now we have a workaround in place which allows us to hard-code
> > > > the PHY id in the compatible property, thus skipping the ID scanning).
> > >
> > > nitpicky, but I think that already existed at that time :D
> >
> > Yes, it has been there are long long time. It is however only in the
> > last 5 years of so has it been seen as a solution to the chicken egg
> > problem.
> >
> > > > sgmii_phy: phy@8 {
> > > > + compatible = "ethernet-phy-id0141.0dd4";
> > > > reg = <0x8>;
> > > > device_type = "ethernet-phy";
> > > > + reset-gpios = <&pmm8654au_2_gpios 8 GPIO_ACTIVE_LOW>;
> > > > + reset-deassert-us = <70000>;
> > >
> > > Doesn't this need reset-assert-us?
> >
> > If i remember correctly, there is a default value if DT does not
> > provide one.
> >
>
> I've been trying to make sure I view devicetree properties as an OS
> agnostic ABI lately, with that in mind...
>
> The dt-binding says this for ethernet-phy:
>
> reset-assert-us:
> description:
> Delay after the reset was asserted in microseconds. If this
> property is missing the delay will be skipped.
>
> If the hardware needs a delay I think we should encode it based on that
> description, else we risk it starting to look like a unit impulse!
>

Please note that the mdio-level delay properties are not the same as
the ones on the PHY levels.

reset-delay-us - this is the delay BEFORE *DEASSERTING* the reset line
reset-post-delay-us - this is the delay AFTER *DEASSERTING* the reset line

On PHY level we have:

reset-assert-us - AFTER *ASSERTING*
reset-deassert-us - AFTER *DEASSERTING*

There never has been any reset-assert delay on that line before. It
doesn't look like we need a delay BEFORE deasserting the line, do we?

Bart

\
 
 \ /
  Last update: 2023-08-08 21:17    [W:0.070 / U:0.004 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site