lkml.org 
[lkml]   [2023]   [Jul]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH] backlight: led_bl: fix initial power state
Date
Daniel Thompson <daniel.thompson@linaro.org> writes:

> On Tue, Jul 04, 2023 at 03:07:50PM +0100, Mans Rullgard wrote:
>> The condition for the initial power state based on the default
>> brightness value is reversed. Fix it.
>>
>> Fixes: ae232e45acf9 ("backlight: add led-backlight driver")
>> Signed-off-by: Mans Rullgard <mans@mansr.com>
>> ---
>> drivers/video/backlight/led_bl.c | 4 ++--
>> 1 file changed, 2 insertions(+), 2 deletions(-)
>>
>> diff --git a/drivers/video/backlight/led_bl.c b/drivers/video/backlight/led_bl.c
>> index 3259292fda76..28e83618a296 100644
>> --- a/drivers/video/backlight/led_bl.c
>> +++ b/drivers/video/backlight/led_bl.c
>> @@ -200,8 +200,8 @@ static int led_bl_probe(struct platform_device *pdev)
>> props.type = BACKLIGHT_RAW;
>> props.max_brightness = priv->max_brightness;
>> props.brightness = priv->default_brightness;
>> - props.power = (priv->default_brightness > 0) ? FB_BLANK_POWERDOWN :
>> - FB_BLANK_UNBLANK;
>> + props.power = (priv->default_brightness > 0) ? FB_BLANK_UNBLANK :
>> + FB_BLANK_POWERDOWN;
>
> The logic was wrong before but I think will still be wrong after the
> change too (e.g. the bogus logic is probably avoiding backlight flicker
> in some use cases).
>
> The logic here needs to be similar to what pwm_bl.c implements in
> pwm_backlight_initial_power_state(). Whilst it might be better
> to implement this in led_bl_get_leds() let me show what I mean
> in code that fits in the current line:
>
> /*
> * Activate the backlight if the LEDs are already lit *or*
> * there is no phandle link (meaning the backlight power
> * state cannot be synced with the display state).
> */
> props.power = (active_at_boot || !dev->node->phandle) ?
> FB_BLANK_UNBLANK : FB_BLANK_POWERDOWN;
>
> Note that active_at_boot is not the same as (priv->default_brightness > 0)
> since the value read by led_bl_get_leds() can be clobbered when we
> parse the properties.

Am I understanding correctly that the code should be using the
default_brightness value as set by led_bl_get_leds() to determine the
initial power state, not whatever default value the devicetree provides?

--
Måns Rullgård

\
 
 \ /
  Last update: 2023-07-04 17:32    [W:0.094 / U:0.624 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site