lkml.org 
[lkml]   [2023]   [Jun]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v4 1/2] dt-bindings: mtd: jedec, spi-nor: Add DT property to avoid setting SRWD bit in status register
Date
If the WP# signal of the flash device is either not connected or is wrongly
tied to GND (that includes internal pull-downs), and the software sets the
status register write disable (SRWD) bit in the status register then the
status register permanently becomes read-only. To avoid this added a new
boolean DT property "no-wp". If this property is set in the DT then the
software avoids setting the SRWD during status register write operation.

Signed-off-by: Amit Kumar Mahapatra <amit.kumar-mahapatra@amd.com>
Reviewed-by: Conor Dooley <conor.dooley@microchip.com>
Reviewed-by: Rob Herring <robh@kernel.org>
Reviewed-by: Michael Walle <michael@walle.cc>
---
.../devicetree/bindings/mtd/jedec,spi-nor.yaml | 15 +++++++++++++++
1 file changed, 15 insertions(+)

diff --git a/Documentation/devicetree/bindings/mtd/jedec,spi-nor.yaml b/Documentation/devicetree/bindings/mtd/jedec,spi-nor.yaml
index 89959e5c47ba..97344969b02d 100644
--- a/Documentation/devicetree/bindings/mtd/jedec,spi-nor.yaml
+++ b/Documentation/devicetree/bindings/mtd/jedec,spi-nor.yaml
@@ -70,6 +70,21 @@ properties:
be used on such systems, to denote the absence of a reliable reset
mechanism.

+ no-wp:
+ type: boolean
+ description:
+ The status register write disable (SRWD) bit in status register, combined
+ with the WP# signal, provides hardware data protection for the device. When
+ the SRWD bit is set to 1, and the WP# signal is either driven LOW or hard
+ strapped to LOW, the status register nonvolatile bits become read-only and
+ the WRITE STATUS REGISTER operation will not execute. The only way to exit
+ this hardware-protected mode is to drive WP# HIGH. If the WP# signal of the
+ flash device is not connected or is wrongly tied to GND (that includes internal
+ pull-downs) then status register permanently becomes read-only as the SRWD bit
+ cannot be reset. This boolean flag can be used on such systems to avoid setting
+ the SRWD bit while writing the status register. WP# signal hard strapped to GND
+ can be a valid use case.
+
reset-gpios:
description:
A GPIO line connected to the RESET (active low) signal of the device.
--
2.17.1
\
 
 \ /
  Last update: 2023-06-30 16:23    [W:2.284 / U:0.004 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site