lkml.org 
[lkml]   [2023]   [May]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH 2/2] drm/panel: Add driver for Visionox r66451 panel
From


On 5/29/2023 5:09 AM, Marijn Suijten wrote:
> On 2023-05-26 09:32:45, Neil Armstrong wrote:
> <snip>
>>>>>>> +static int visionox_r66451_bl_update_status(struct backlight_device *bl)
>>>>>>> +{
>>>>>>> +    struct mipi_dsi_device *dsi = bl_get_data(bl);
>>>>>>> +    u16 brightness = backlight_get_brightness(bl);
>>>>>>> +
>>>>>>> +    return mipi_dsi_dcs_set_display_brightness(dsi, cpu_to_le16(brightness));
>>>>>>
>>>>>> mipi_dsi_dcs_set_display_brightness() already converts the brightness,
>>>>>> so you don't need cpu_to_le16 here.
>>>>>
>>>>> Tread carefully here: we've had the same issue and conversation on our
>>>>> Sony panels where this extra inversion is required.
>>>>> set_display_brightness() sends the bytes as little-endian to the panel
>>>>> (and it even assumes little-endian in get_display_brightness()) but the
>>>>> spec for 16-bit brightness values states that they have to be sent in
>>>>> big-endian.  This is why c9d27c6be518b ("drm/mipi-dsi: Fix byte order of
>>>>> 16-bit DCS set/get brightness") added
>>>>> mipi_dsi_dcs_set_display_brightness_large().
>>>>>
>>>>> Jessica, if you need to have the endian swap here (should be very easy
>>>>> to test with a real panel, but it should be given the max_brightness
>>>>> value being over 8 bits) please switch to the _large() variant.
>>>>
>>>> Got it, thanks for the heads up!
>>>
>>> Hi Marijn,
>>>
>>> Just wanted to update this thread -- I've checked the backlight brightness values in the sysfs and it matches the value being given in the panel driver (255), so I think it should be fine to use *_set_display_brightness() without the _large() variant.
>>
>> Sure, I was also misleaded by you using cpu_to_le16() but as Dmitry said it's already
>> done in mipi_dsi_dcs_set_display_brightness() and a no-op on LE arm64 platforms anyway.
>
> Yuck, right, it's cpu_to_le16 here and not cpu_to_be16. @Jessica, can
> you please remove this misleading conversion?
> mipi_dsi_dcs_set_display_brightness() takes a native u16, not a specific
> __le16.

Hi Marijn,

Acked, will drop the conversion.

Thanks,

Jessica Zhang

>
> - Marijn

\
 
 \ /
  Last update: 2023-05-30 19:44    [W:0.056 / U:0.152 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site