lkml.org 
[lkml]   [2023]   [May]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[net-next PATCH v2 02/13] leds: add API to get attached device for LED hw control
Date
From: Andrew Lunn <andrew@lunn.ch>

Some specific LED triggers blink the LED based on events from a device
or subsystem.
For example, an LED could be blinked to indicate a network device is
receiving packets, or a disk is reading blocks. To correctly enable and
request the hw control of the LED, the trigger has to check if the
network interface or block device configured via a /sys/class/led file
match the one the LED driver provide for hw control for.

Provide an API call to get the device which the LED blinks for.

Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Christian Marangi <ansuelsmth@gmail.com>
---
include/linux/leds.h | 6 ++++++
1 file changed, 6 insertions(+)

diff --git a/include/linux/leds.h b/include/linux/leds.h
index 4caf559b1922..3268b4e789d6 100644
--- a/include/linux/leds.h
+++ b/include/linux/leds.h
@@ -220,6 +220,12 @@ struct led_classdev {
*/
int (*hw_control_get)(struct led_classdev *led_cdev,
unsigned long *flags);
+ /*
+ * Get the device this LED blinks in response to.
+ * e.g. for a PHY LED, it is the network device. If the LED is
+ * not yet associated to a device, return NULL.
+ */
+ struct device *(*hw_control_get_device)(struct led_classdev *led_cdev);
#endif

#ifdef CONFIG_LEDS_BRIGHTNESS_HW_CHANGED
--
2.39.2
\
 
 \ /
  Last update: 2023-05-25 16:56    [W:0.437 / U:0.288 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site