lkml.org 
[lkml]   [2023]   [Apr]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Date
Subject[PATCH 5/5] ARM: dts: qcom: apq8026-huawei-sturgeon: Add vibrator
The watch has a DRV2605 for haptics. Add a node for it based on the
values found in the downstream board file.

Signed-off-by: Luca Weiss <luca@z3ntu.xyz>
---
arch/arm/boot/dts/qcom-apq8026-huawei-sturgeon.dts | 28 ++++++++++++++++++++++
1 file changed, 28 insertions(+)

diff --git a/arch/arm/boot/dts/qcom-apq8026-huawei-sturgeon.dts b/arch/arm/boot/dts/qcom-apq8026-huawei-sturgeon.dts
index d64096028ab1..eb73b992a696 100644
--- a/arch/arm/boot/dts/qcom-apq8026-huawei-sturgeon.dts
+++ b/arch/arm/boot/dts/qcom-apq8026-huawei-sturgeon.dts
@@ -7,6 +7,7 @@

#include "qcom-msm8226.dtsi"
#include "qcom-pm8226.dtsi"
+#include <dt-bindings/input/ti-drv260x.h>

/delete-node/ &adsp_region;

@@ -68,6 +69,26 @@ &adsp {
status = "okay";
};

+&blsp1_i2c2 {
+ clock-frequency = <384000>;
+
+ status = "okay";
+
+ vibrator@5a {
+ compatible = "ti,drv2605";
+ reg = <0x5a>;
+ enable-gpios = <&tlmm 60 GPIO_ACTIVE_HIGH>;
+
+ mode = <DRV260X_ERM_MODE>;
+ library-sel = <DRV260X_ERM_LIB_D>;
+ vib-rated-mv = <2765>;
+ vib-overdrive-mv = <3525>;
+
+ pinctrl-0 = <&vibrator_default_state>;
+ pinctrl-names = "default";
+ };
+};
+
&blsp1_i2c5 {
clock-frequency = <384000>;

@@ -347,6 +368,13 @@ reset-pins {
};
};

+ vibrator_default_state: vibrator-default-state {
+ pins = "gpio59", "gpio60";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-pull-down;
+ };
+
wlan_hostwake_default_state: wlan-hostwake-default-state {
pins = "gpio66";
function = "gpio";
--
2.40.1

\
 
 \ /
  Last update: 2023-04-30 20:23    [W:0.085 / U:0.044 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site