lkml.org 
[lkml]   [2023]   [Mar]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH 0/3] clk: imx: Improve imx8mm/imx8mn LCDIF clocks
Date
Both the i.MX8M Mini and Nano have a video_pll which can be used 
to source a clock which feeds the lcdif interface. This interface
currently fixes video_pll and divides down the clock feeding LCDIF.
However, when connected to an HDMI bridge chip that supports a
variety of video resolutions and refresh rates, the only settings
that properly sync are ones that evenly divide from the video_pll_out
clock.

This series adds the ability for the clk-compolsite-8m to
request a better parent clock if the proper clock flag is
enabled, then sets that flag in the corresponding imx8mm and
imx8mn clocks.

This also has a side benefit of allowing the video-pll to run
at a lower clock speed which can potentially save some power
depending on the requested resolution and refresh rate.

Adam Ford (3):
clk: imx: composite-8m: Add support to determine_rate
clk: imx8mm: Let IMX8MM_CLK_LCDIF_PIXEL set parent rate
clk: imx: Let IMX8MN_CLK_DISP_PIXEL set parent rate

drivers/clk/imx/clk-composite-8m.c | 7 +++++++
drivers/clk/imx/clk-imx8mm.c | 2 +-
drivers/clk/imx/clk-imx8mn.c | 2 +-
drivers/clk/imx/clk.h | 4 ++++
4 files changed, 13 insertions(+), 2 deletions(-)

--
2.34.1

\
 
 \ /
  Last update: 2023-03-27 01:06    [W:0.107 / U:0.252 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site