Messages in this thread Patch in this message | | | From | Vinod Polimera <> | Subject | [PATCH v13 07/13] drm/msm/disp/dpu: reset the datapath after timing engine disable | Date | Sun, 12 Feb 2023 21:58:51 +0530 |
| |
Reset the datapath after disabling the timing gen, such that it can start on a clean slate when the intf is enabled back. This was a recommended sequence from the DPU HW programming guide.
Signed-off-by: Vinod Polimera <quic_vpolimer@quicinc.com> Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org> --- drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_vid.c | 1 + 1 file changed, 1 insertion(+)
diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_vid.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_vid.c index 0396084..3a37429 100644 --- a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_vid.c +++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_vid.c @@ -588,6 +588,7 @@ static void dpu_encoder_phys_vid_disable(struct dpu_encoder_phys *phys_enc) } } + dpu_encoder_helper_phys_cleanup(phys_enc); phys_enc->enable_state = DPU_ENC_DISABLED; } -- 2.7.4
| |