lkml.org 
[lkml]   [2023]   [Dec]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Date
Subject[PATCH 10/12] arm64: dts: qcom: sm8550: Switch UFS from opp-table-hz to opp-v2
Now that the non-legacy form of OPP is supported within the UFS driver,
go ahead and switch to it, adding support for more intermediate freq/power
states.

In doing so, add the CX RPMhPD under GCC to make sure at least some of
the power state requirements are *actually* propagated up the stack.

Signed-off-by: Konrad Dybcio <konrad.dybcio@linaro.org>
---
arch/arm64/boot/dts/qcom/sm8550.dtsi | 50 +++++++++++++++++++++++++++++-------
1 file changed, 41 insertions(+), 9 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/sm8550.dtsi b/arch/arm64/boot/dts/qcom/sm8550.dtsi
index d707d15cea5b..d6edd54f3ad3 100644
--- a/arch/arm64/boot/dts/qcom/sm8550.dtsi
+++ b/arch/arm64/boot/dts/qcom/sm8550.dtsi
@@ -1930,6 +1930,7 @@ ufs_mem_hc: ufs@1d84000 {
iommus = <&apps_smmu 0x60 0x0>;
dma-coherent;

+ operating-points-v2 = <&ufs_opp_table>;
interconnects = <&aggre1_noc MASTER_UFS_MEM 0 &mc_virt SLAVE_EBI1 0>,
<&gem_noc MASTER_APPSS_PROC 0 &config_noc SLAVE_UFS_MEM_CFG 0>;

@@ -1950,18 +1951,49 @@ ufs_mem_hc: ufs@1d84000 {
<&gcc GCC_UFS_PHY_TX_SYMBOL_0_CLK>,
<&gcc GCC_UFS_PHY_RX_SYMBOL_0_CLK>,
<&gcc GCC_UFS_PHY_RX_SYMBOL_1_CLK>;
- freq-table-hz =
- <75000000 300000000>,
- <0 0>,
- <0 0>,
- <75000000 300000000>,
- <100000000 403000000>,
- <0 0>,
- <0 0>,
- <0 0>;
qcom,ice = <&ice>;

status = "disabled";
+
+ ufs_opp_table: opp-table {
+ compatible = "operating-points-v2";
+
+ opp-75000000 {
+ opp-hz = /bits/ 64 <75000000>,
+ /bits/ 64 <0>,
+ /bits/ 64 <0>,
+ /bits/ 64 <75000000>,
+ /bits/ 64 <100000000>,
+ /bits/ 64 <0>,
+ /bits/ 64 <0>,
+ /bits/ 64 <0>;
+ required-opps = <&rpmhpd_opp_low_svs>;
+ };
+
+ opp-150000000 {
+ opp-hz = /bits/ 64 <150000000>,
+ /bits/ 64 <0>,
+ /bits/ 64 <0>,
+ /bits/ 64 <150000000>,
+ /bits/ 64 <100000000>,
+ /bits/ 64 <0>,
+ /bits/ 64 <0>,
+ /bits/ 64 <0>;
+ required-opps = <&rpmhpd_opp_svs>;
+ };
+
+ opp-300000000 {
+ opp-hz = /bits/ 64 <300000000>,
+ /bits/ 64 <0>,
+ /bits/ 64 <0>,
+ /bits/ 64 <300000000>,
+ /bits/ 64 <100000000>,
+ /bits/ 64 <0>,
+ /bits/ 64 <0>,
+ /bits/ 64 <0>;
+ required-opps = <&rpmhpd_opp_nom>;
+ };
+ };
};

ice: crypto@1d88000 {
--
2.43.0


\
 
 \ /
  Last update: 2023-12-18 17:06    [W:0.063 / U:0.692 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site