lkml.org 
[lkml]   [2023]   [Jan]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH 2/7] clk: qcom: Add Global Clock Controller driver for IPQ9574
From


On 24.01.2023 08:27, Devi Priya wrote:
>
>
> On 1/13/2023 7:39 PM, Konrad Dybcio wrote:
>>
>>
>> On 13.01.2023 14:21, Devi Priya wrote:
>>>
>>>
>>> On 1/10/2023 6:07 PM, Konrad Dybcio wrote:
>>>>
>>>>
>>>> On 10.01.2023 13:13, devi priya wrote:
>>>>> Add Global Clock Controller (GCC) driver for ipq9574 based devices
>>>>>
>>>>> Co-developed-by: Anusha Rao <quic_anusha@quicinc.com>
>>>>> Signed-off-by: Anusha Rao <quic_anusha@quicinc.com>
>>>>> Signed-off-by: devi priya <quic_devipriy@quicinc.com>
>>>>> ---
>> [...]
>>
>>>>> +static struct clk_branch gcc_blsp1_qup6_i2c_apps_clk = {
>>>>> +    .halt_reg = 0x07024,
>>>>> +    .clkr = {
>>>>> +        .enable_reg = 0x07024,
>>>>> +        .enable_mask = BIT(0),
>>>>> +        .hw.init = &(struct clk_init_data) {
>>>>> +            .name = "gcc_blsp1_qup6_i2c_apps_clk",
>>>>> +            .parent_hws = (const struct clk_hw *[]) {
>>>>> +                    &blsp1_qup6_i2c_apps_clk_src.clkr.hw },
>>>>> +            .num_parents = 1,
>>>>> +            .flags = CLK_SET_RATE_PARENT | CLK_IGNORE_UNUSED,
>>>> Sounds very much like a hack..
>>> Got it, will remove the clock entry as it is not being used in linux
>> I'm not sure removing it is the best option, somebody might have a
>> funky board where they use this particular QUP for I2C for whatever
>> reason and then the clock would have to be re-added..
> Sure, Understood
> This clock is used by the RPM component to communicate with PMIC and we
> would add the critical flag here
Okay, so this SoC is intended to ship with some RPM PMICs and
*always* with an I2C companion that's required for some basic
functionality, correct?

Otherwise, if it's just for wifi/multimedia/etc (like PM8008ij
on some newer devices), you should not make it critical and
simply rely on Linux keeping it alive like so:

consumer takes a regulator
the regulator does not go to sleep because it's consumed
the PMIC is active because a regulator on it is being used
the I2C bus is active because its child PMIC is used
the I2C clocks are alive because there's an active user

Konrad
>
>> Thanks for addressing all of the review comments so thoroughly!
>>
>> Konrad
>
> Best Regards,
> Devi Priya

\
 
 \ /
  Last update: 2023-03-26 23:53    [W:0.589 / U:0.172 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site