lkml.org 
[lkml]   [2023]   [Jan]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v3 1/2] dt-bindings: net: Add ICSSG Ethernet Driver bindings
From


On 23/12/2022 16:28, Andrew Lunn wrote:
>> + ethernet-ports {
>> + #address-cells = <1>;
>> + #size-cells = <0>;
>> + pruss2_emac0: port@0 {
>> + reg = <0>;
>> + phy-handle = <&pruss2_eth0_phy>;
>> + phy-mode = "rgmii-rxid";
>
> That is unusual. Where are the TX delays coming from?

From the below property

+ ti,syscon-rgmii-delay = <&scm_conf 0x4120>;

The TX delay can be enabled/disabled from within the ICSSG block.

If this property exists and PHY mode is neither PHY_INTERFACE_MODE_RGMII_ID
nor PHY_INTERFACE_MODE_RGMII_TXID then the internal delay is enabled.

This logic is in prueth_config_rgmiidelay() function in the introduced driver.

>
> Andrew

cheers,
-roger

\
 
 \ /
  Last update: 2023-03-26 23:24    [W:0.039 / U:0.296 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site