lkml.org 
[lkml]   [2022]   [Sep]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH v6 06/17] dt-bindings: mfd: amd,pensando-elbasr: Add AMD Pensando Elba System Resource chip
Date
On 9/16/22 2:56 AM, Krzysztof Kozlowski wrote:
> Caution: This message originated from an External Source. Use proper caution when opening attachments, clicking links, or responding.
>
>
> On 13/09/2022 22:57, Larson, Bradley wrote:
>> On 9/8/22 4:27 AM, Krzysztof Kozlowski wrote:
>>> On 01/09/2022 22:37, Larson, Bradley wrote:
>>>> On 9/1/22 12:20 AM, Krzysztof Kozlowski wrote:
>>>>> On 01/09/2022 02:01, Larson, Bradley wrote:
>>>>>
> Wait, can we skip the driver entirely? I am not reviewing your driver
> and what it creates under /dev.

Yes, see precise answer requested below.

>> In comparision, the pensando device is also on the other end of spi,
>> four chip selects with /dev created for each for userspace control,
>> and one child device on cs0 for hw reset emmc that the Linux block
>> layer controls (single bit managed only by kernel).
>>
>> Pensando:
>> &spi0 {
>> num-cs = <4>;
>> cs-gpios = <0>, <0>, <&porta 1 GPIO_ACTIVE_LOW>,
>> <&porta 7 GPIO_ACTIVE_LOW>;
>> status = "okay";
>> system-controller@0 {
>> compatible = "amd,pensando-elbasr";
>> reg = <0>;
>> #address-cells = <1>;
>> #size-cells = <0>;
>> spi-max-frequency = <12000000>;
>>
>> rstc: reset-controller {
>> compatible = "amd,pensando-elbasr-reset";
>> #reset-cells = <1>;
>> };
>> };
>>
>> system-controller@1 {
>> compatible = "amd,pensando-elbasr";
>> reg = <1>;
>> spi-max-frequency = <12000000>;
>> };
>>
>> system-controller@2 {
>> compatible = "amd,pensando-elbasr";
>> reg = <2>;
>> spi-max-frequency = <12000000>;
>> interrupt-parent = <&porta>;
>> interrupts = <0 IRQ_TYPE_LEVEL_LOW>;
>> };
>>
>> system-controller@3 {
>> compatible = "amd,pensando-elbasr";
>> reg = <3>;
>> spi-max-frequency = <12000000>;
>> };
>> };
> You replied with quite a response of which 90% is unrelated talk about
> driver. Please be specific. We talk here only about hardware.
> Your last DTS might be the answer, but you never explicitly wrote
> it... So let's check if I understand it correctly. Only some of elbasr
> block contain reset control?

Yes, only the elbasr block accessed on CS0 provides reset control.  The
other 3 blocks don't have any reset control and never will.

> This however does not answer my questions before.... You keep ignoring
> them. So please answer yes or no: "Are there other sub-devices?"

No

> " and your binding is incomplete?"

No

> and a new question: "Is reset block (amd,pensando-elbasr-reset)
> re-usable so it will appear in different device (not in
> amd,pensando-elbasr)?"

No its not re-usable

Regards,
Brad


\
 
 \ /
  Last update: 2022-09-30 00:51    [W:0.101 / U:0.612 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site