lkml.org 
[lkml]   [2022]   [Sep]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    Date
    SubjectRe: [PATCH 08/12] dt-bindings: pinctrl: qcom,sm8250-lpass-lpi: add bias-bus-hold and input-enable
    From
    On 23/09/2022 11:31, Krzysztof Kozlowski wrote:
    > On Thu, 22 Sep 2022 21:56:47 +0200, Krzysztof Kozlowski wrote:
    >> The existing SC7280 LPASS pin controller nodes use bias-bus-hold and
    >> input-enable, so allow them. Squash also blank lines for readability.
    >>
    >> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
    >> ---
    >> .../bindings/pinctrl/qcom,sm8250-lpass-lpi-pinctrl.yaml | 6 ++----
    >> 1 file changed, 2 insertions(+), 4 deletions(-)
    >>
    >
    > Running 'make dtbs_check' with the schema in this patch gives the
    > following warnings. Consider if they are expected or the schema is
    > incorrect. These may not be new warnings.
    >
    > Note that it is not yet a requirement to have 0 warnings for dtbs_check.
    > This will change in the future.
    >
    > Full log is available here: https://patchwork.ozlabs.org/patch/1681325
    >
    >
    > pinctrl@33c0000: 'dmic01-active-pins', 'dmic01-sleep-pins', 'rx_swr-active-pins', 'tx_swr-active-pins', 'tx_swr-sleep-pins', 'wsa-swr-active-pins', 'wsa-swr-sleep-pins' do not match any of the regexes: '-state$', 'pinctrl-[0-9]+'

    This is being fixed in next DTS patches. I'll reorganize them if there
    is going to be a resubmit.

    Best regards,
    Krzysztof

    \
     
     \ /
      Last update: 2022-09-23 12:33    [W:6.618 / U:0.008 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site