Messages in this thread | | | From | Neil Armstrong <> | Subject | Re: (subset) [PATCH 0/4] drm/bridge: lt8912b: Fix corrupt display output due to wrong bridge config | Date | Fri, 23 Sep 2022 09:25:15 +0000 |
| |
Hi,
On Thu, 22 Sep 2022 14:43:02 +0200, Philippe Schenker wrote: > From: Philippe Schenker <philippe.schenker@toradex.com> > > This patch-set fixes the lt8912b driver that currently does not take > care whether or not the attached display has postiive or negative syncs > and or reports on EDID if it needs HDMI mode or DVI. > > This series addresses also an issue where the LVDS startup sequence was > written to the wrong I2C address (the lt8912 has three). This caused > writing into reserved registers and causing an unstable HDMI picture > that manifests itself only sometimes and depending on the monitor with a > flickering and a repeating of going black and coming up again. While at > it move also some sensible comments to the sequence. > > [...]
Thanks, Applied to https://anongit.freedesktop.org/git/drm/drm-misc.git (drm-misc-next)
[4/4] drm/bridge: lt8912b: clarify lvds output status https://cgit.freedesktop.org/drm/drm-misc/commit/?id=fc44f3636a4db6544fd1532280e8adcd1ef13ba2
-- Neil
| |