lkml.org 
[lkml]   [2022]   [Aug]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2 14/16] hwmon: (mr75203) parse thermal coefficients from device-tree
Date
From
On 8/18/2022 11:28 PM, Guenter Roeck wrote:
> The calculation was just changed to use new defaults in a previous
> patch. This patch makes it quite clear that the coefficients
> are implementation (?) dependent. So the previous patch just changes
> the defaults to (presumably) the coefficients used in your system.
> That is inappropriate. Adding non-default corefficients is ok
> and makes sense is supported by the chip, but changing defaults
> isn't.
The calculation was changed in previous patch to match series 5 of the
Moortec Embedded Temperature Sensor (METS) datasheet.
In our SOC we use series 6 which has a slightly different equation and
different coefficients.
I did the changes in steps.
With this last change, both series 5 and 6 are supported, in addition to
calibrated vs. non-calibrated modes.
In addition the data sheet just recommends default values but they also
specifically mention that actual values might vary from product to product.

--
Regards, Eliav

\
 
 \ /
  Last update: 2022-08-19 09:59    [W:0.059 / U:2.856 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site