lkml.org 
[lkml]   [2022]   [Aug]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/4] PCI: mvebu: Implement support for interrupts on emulated bridge
On Thu, Aug 18, 2022 at 10:07:37PM +0200, Pali Rohár wrote:
> On Thursday 18 August 2022 21:51:21 Andrew Lunn wrote:
> > > -static irqreturn_t mvebu_pcie_irq_handler(int irq, void *arg)
> > > +static irqreturn_t mvebu_pcie_error_irq_handler(int irq, void *arg)
> > > +{
> > > + struct mvebu_pcie_port *port = arg;
> > > + struct device *dev = &port->pcie->pdev->dev;
> > > + u32 cause, unmask, status;
> > > +
> > > + cause = mvebu_readl(port, PCIE_INT_CAUSE_OFF);
> > > + unmask = mvebu_readl(port, PCIE_INT_UNMASK_OFF);
> > > + status = cause & unmask;
> > > +
> > > + /* "error" interrupt handler does not process INTX interrupts */
> > > + status &= ~(PCIE_INT_INTX(0) | PCIE_INT_INTX(1) |
> > > + PCIE_INT_INTX(2) | PCIE_INT_INTX(3));
> >
> > Just for my understanding...
> >
> > There are two interrupts
>
> yes
>
> > but the status information what those
> > interrupts actually mean are all packed into one register?
>
> yes
>
> for masking individual interrupt events there is just one shared
> register for both "intx" and "error" interrupt source.
>
> and also there is also just one shared "cause" register which says which
> individual interrupt events happened.
>
> > I assume reading the clause register does not clear set bits?
>
> yes, reading does not clear any interrupt event.
>
> > Otherwise there
> > would be a race condition.
>
> > Are these actually level interrupts
>
> yes
>
> > and in order to clear them you need to poke some other register?
>
> to clear individual interrupt event you have to write corresponding 1b
> bit into that cause register.
>
> so if interrupts events BIT(24), BIT(16) and BIT(17) happened and
> BIT(24), BIT(25), BIT(26), BIT(27) and BIT(16) are unmasked then CPU
> receives two interrupts (one for intx:24-27 and one for err:16). kernel
> will call interrupt handlers for both intx and err (possible also in
> parallel if it unmasked on different CPUs) and each handler just clears
> events which process. So writing BIT(16) into cause register clears only
> event 16 and all other (24-27, 17) are still active. And level interrupt
> (the correct one intx or err) is then triggered again.

Thanks for the explanation.

I don't know enough about PCI to be able to give a meaningful
Reviewed-by, so i will leave that to the PCI maintainer. But the DT
bits look good to me.

Andrew

\
 
 \ /
  Last update: 2022-08-18 22:29    [W:0.059 / U:0.524 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site