lkml.org 
[lkml]   [2022]   [Jun]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v5 5/9] drm/bridge: anx7625: Add typec_mux_set callback function
Quoting Prashant Malani (2022-06-28 13:56:22)
> On Tue, Jun 28, 2022 at 1:40 PM Stephen Boyd <swboyd@chromium.org> wrote:
> >
> > I suppose none of those things matter though as long as there is some
> > typec switch registered here so that the driver can be informed of the
> > pin assignment. Is it right that the "mode-switch" property is only
> > required in DT if this device is going to control the mode of the
> > connector, i.e. USB+DP, or just DP? Where this device can't do that
> > because it doesn't support only DP.
>
> If the anx7625 is used just to route all lanes from 1 usb-c-connector (i.e
> the USB+DP case), a mode-switch wouldn't be of much use, since one
> would also route the CC lines to the built-in PD controller; so it will
> already have knowledge of what mode the switch is in.
>
> The mode-switch is likely only relevant for this hardware configuration(
> it's "DP only" in the sense that the USB pins to the SoC never go anywhere).
> One only has 2 SS lanes each (from each usb-c-connector).
>
> Since there is no CC-line, the anx7625 needs to know which one has DP
> enabled on it.

Can the CC line be "captured" and not actually sent to the anx7625? I
imagine if that is possible, maybe the CC lines would go to some
micro-controller or something that did more typec management things and
then the anx7625 driver would need to do software control of the mode
and orientation control.

\
 
 \ /
  Last update: 2022-07-01 01:23    [W:0.085 / U:0.244 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site