lkml.org 
[lkml]   [2022]   [Jun]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH 1/2] dt-bindings: net: wireless: ath11k: add new DT entry for board ID
From
On 21/06/2022 20:47, Robert Marko wrote:
> On Tue, 21 Jun 2022 at 17:58, Krzysztof Kozlowski
> <krzysztof.kozlowski@linaro.org> wrote:
>>
>> On 21/06/2022 15:53, Robert Marko wrote:
>>> bus + qmi-chip-id + qmi-board-id and optionally the variant are currently
>>> used for identifying the correct board data file.
>>>
>>> This however is sometimes not enough as all of the IPQ8074 boards that I
>>> have access to dont have the qmi-board-id properly fused and simply return
>>> the default value of 0xFF.
>>>
>>> So, to provide the correct qmi-board-id add a new DT property that allows
>>> the qmi-board-id to be overridden from DTS in cases where its not set.
>>> This is what vendors have been doing in the stock firmwares that were
>>> shipped on boards I have.
>>>
>>> Signed-off-by: Robert Marko <robimarko@gmail.com>
>>
>> Thank you for your patch. There is something to discuss/improve.
>>
>>> ---
>>> .../devicetree/bindings/net/wireless/qcom,ath11k.yaml | 8 ++++++++
>>> 1 file changed, 8 insertions(+)
>>>
>>> diff --git a/Documentation/devicetree/bindings/net/wireless/qcom,ath11k.yaml b/Documentation/devicetree/bindings/net/wireless/qcom,ath11k.yaml
>>> index a677b056f112..fe6aafdab9d4 100644
>>> --- a/Documentation/devicetree/bindings/net/wireless/qcom,ath11k.yaml
>>> +++ b/Documentation/devicetree/bindings/net/wireless/qcom,ath11k.yaml
>>> @@ -41,6 +41,14 @@ properties:
>>> * reg
>>> * reg-names
>>>
>>> + qcom,ath11k-board-id:
>>
>> The "board" a bit confuses me because in the context of entire system it
>> means the entire hardware running Qualcomm SoC. This is sometimes
>> encoded as qcom,board-id property.
>
> Hi Krzysztof,
> I agree that the name is a bit confusing, it's not the same as
> qcom,board-id AFAIK
> and QCA as well as vendors are using a similar property in the wifi
> node to override
> the default qmi-board-id to the correct one as its rarely properly fused.
>
> I assume it would be better-called qcom,ath11k-qmi-board-id as you
> dont even have
> to be using a Qualcomm SoC as the same is used by PCI ath11k cards as well.
>

Thanks for the explanation. What is the "board" in that context? The
card/hardware with ath11k? Then maybe qcom,ath11k-qmi-id or
qcom,ath11k-qmi-hw-id?

Best regards,
Krzysztof

\
 
 \ /
  Last update: 2022-06-22 16:57    [W:0.055 / U:0.504 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site