lkml.org 
[lkml]   [2022]   [Apr]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] net: phy: genphy_loopback: fix loopback failed when speed is unknown
On Fri, Apr 08, 2022 at 10:18:24AM +0200, Oleksij Rempel wrote:
> On Thu, Apr 07, 2022 at 04:45:03PM +0200, Andrew Lunn wrote:
> > > Hi Andrew,
> > > The PHY we test is RTL8211F, it supports 10 half. This problem actually is,
> > > our board has MAC connected with PHY, when loopback test, packet flow is
> > > MAC->PHY->MAC, it needs speed of MAC and PHY should be same when they work.
> > >
> > > If PHY speed is unknown when PHY goes down, we will not set MAC speed in
> > > adjust_link interface. In this case, we hope that PHY speed should not be
> > > changed, as the old code of function genphy_loopback() before patch
> > > "net: phy: genphy_loopback: add link speed configuration".
> > >
> > > If PHY has never link, MAC speed has never be set in adjust_link interface,
> > > yeah, in this case, MAC and PHY may has different speed, and they can not work.
> > > I think we can accept this situation.
> > >
> > > I think it is general problem if there is MAC connected with PHY.
> >
> > Thanks for investigating. Looks like we are getting close the real
> > solution. And it is a generic problem, that the MAC and PHY might not
> > be using the same configuration.
> >
> > So it looks like if the link is down, or speed is UNKNOWN, we need to
> > set phydev->link true, speed 10, duplex half...
>
> Hm, i was thinking, is it impossible to run loopback test on half duplex link.
> Do I missing something?

Ah, you might be right. I was just thinking of the lowest common
denominator. So 10 Full. Or maybe even look at phydev->supported and
pick one from there.

Andrew

\
 
 \ /
  Last update: 2022-04-08 15:05    [W:0.057 / U:0.344 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site