lkml.org 
[lkml]   [2022]   [Apr]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] spi: rockchip: fix missing error on unsupported SPI_CS_HIGH
Date
The hardware (except for the ROCKCHIP_SPI_VER2_TYPE2 version) does not
support active-high native chip selects. However if such a CS is configured
the core does not error as it normally should, because the
'ctlr->use_gpio_descriptors = true' line in rockchip_spi_probe() makes the
core set SPI_CS_HIGH in ctlr->mode_bits.

In such a case the spi-rockchip driver operates normally but produces an
active-low chip select signal without notice.

There is no provision in the current core code to handle this
situation. Fix by adding a check in the ctlr->setup function (similarly to
what spi-atmel.c does).

This cannot be done reading the SPI_CS_HIGH but in ctlr->mode_bits because
that bit gets always set by the core for master mode (see above).

Fixes: eb1262e3cc8b ("spi: spi-rockchip: use num-cs property and ctlr->enable_gpiods")
Signed-off-by: Luca Ceresoli <luca.ceresoli@bootlin.com>
---
drivers/spi/spi-rockchip.c | 8 ++++++++
1 file changed, 8 insertions(+)

diff --git a/drivers/spi/spi-rockchip.c b/drivers/spi/spi-rockchip.c
index cdc16eecaf6b..a08215eb9e14 100644
--- a/drivers/spi/spi-rockchip.c
+++ b/drivers/spi/spi-rockchip.c
@@ -196,6 +196,8 @@ struct rockchip_spi {

bool slave_abort;
bool cs_inactive; /* spi slave tansmition stop when cs inactive */
+ bool cs_high_supported; /* native CS supports active-high polarity */
+
struct spi_transfer *xfer; /* Store xfer temporarily */
};

@@ -719,6 +721,11 @@ static int rockchip_spi_setup(struct spi_device *spi)
struct rockchip_spi *rs = spi_controller_get_devdata(spi->controller);
u32 cr0;

+ if (!spi->cs_gpiod && (spi->mode & SPI_CS_HIGH) && !rs->cs_high_supported) {
+ dev_warn(&spi->dev, "setup: non GPIO CS can't be active-high\n");
+ return -EINVAL;
+ }
+
pm_runtime_get_sync(rs->dev);

cr0 = readl_relaxed(rs->regs + ROCKCHIP_SPI_CTRLR0);
@@ -899,6 +906,7 @@ static int rockchip_spi_probe(struct platform_device *pdev)

switch (readl_relaxed(rs->regs + ROCKCHIP_SPI_VERSION)) {
case ROCKCHIP_SPI_VER2_TYPE2:
+ rs->cs_high_supported = true;
ctlr->mode_bits |= SPI_CS_HIGH;
if (ctlr->can_dma && slave_mode)
rs->cs_inactive = true;
--
2.25.1
\
 
 \ /
  Last update: 2022-04-21 23:35    [W:0.036 / U:0.288 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site