lkml.org 
[lkml]   [2022]   [Dec]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 3/4] arm64: dts: qcom: sa8540p-ride: add qup1_i2c15 and qup2_i2c18 nodes
On Wed, Dec 14, 2022 at 09:06:48PM +0530, Shazad Hussain wrote:
> > i2c0_default: i2c0-default-state {
> > pins = "gpio135", "gpio136";
> > function = "qup15";
> > drive-strength = <2>;
> > bias-pull-up;
> > };
> >
>
> This is the default config we should use.

OK, I'll stick with this config.

> > Shazad: 'i2cdetect -a -y $BUSNUM) shows that all 5 buses have the same
> > addresses listening. Is that expected? That seems a bit odd to me.
> >
>
> Brian, even I haven't checked with all enabled, let me check this on other
> projects and with downstream as well and get back to you.

I'll post my v2 in a little bit so that you can test it.

Brian

\
 
 \ /
  Last update: 2022-12-14 17:26    [W:0.058 / U:0.680 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site