lkml.org 
[lkml]   [2022]   [Jan]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 3/4] serial: stm32: fix flow control transfer in DMA mode
Date
If flow control is enabled, framework will call stop_tx to
pause transfer and then call start_tx to resume transfer.

Clear USART_CR3_DMAT bit in stop_tx ops to pause DMA transfer.

Signed-off-by: Erwan Le Ray <erwan.leray@foss.st.com>
Signed-off-by: Valentin Caron <valentin.caron@foss.st.com>
---
drivers/tty/serial/stm32-usart.c | 3 +++
1 file changed, 3 insertions(+)

diff --git a/drivers/tty/serial/stm32-usart.c b/drivers/tty/serial/stm32-usart.c
index 52755a576bc2..788e002688f2 100644
--- a/drivers/tty/serial/stm32-usart.c
+++ b/drivers/tty/serial/stm32-usart.c
@@ -707,8 +707,11 @@ static void stm32_usart_stop_tx(struct uart_port *port)
{
struct stm32_port *stm32_port = to_stm32_port(port);
struct serial_rs485 *rs485conf = &port->rs485;
+ const struct stm32_usart_offsets *ofs = &stm32_port->info->ofs;

stm32_usart_tx_interrupt_disable(port);
+ if (stm32_usart_tx_dma_started(stm32_port) && stm32_usart_tx_dma_enabled(stm32_port))
+ stm32_usart_clr_bits(port, ofs->cr3, USART_CR3_DMAT);

if (rs485conf->flags & SER_RS485_ENABLED) {
if (rs485conf->flags & SER_RS485_RTS_ON_SEND) {
--
2.17.1
\
 
 \ /
  Last update: 2022-01-04 19:26    [W:0.033 / U:0.028 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site