lkml.org 
[lkml]   [2021]   [Sep]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH 3/4] arm64: dts: marvell: espressobin-ultra: add PHY and switch reset pins
On Tue, Sep 28, 2021 at 5:32 PM Pali Rohár <pali@kernel.org> wrote:
>
> On Monday 27 September 2021 17:41:58 Robert Marko wrote:
> > Both the Topaz switch and 88E1512 PHY have their reset and interrupts
> > connected to the SoC.
> >
> > So, define the Topaz and 88E1512 reset pins in the DTS.
>
> Are reset pins connected only on ultra variant? Or on all espressobin
> variants? Because if they are on all variants then definitions should go
> into common dtsi file.
>
> I see that "gpionb 2" is on v7 variant connected to LED2. So I'm not
> sure if this one gpio is also shared or not.

As far as I know only Ultra has the reset pins connected, on the v5 and v7 Topaz
reset is tied to the system reset so it's not controllable.
I checked both the v5 and v7 schematics and it's like that.
>
> > Defining the interrupt pins wont work as both the 88E1512 and the
> > Topaz switch uses active LOW IRQ signals but the A37xx GPIO controller
> > only supports edge triggers.
> > 88E1512 would require special setup anyway as its INT pin is shared with
> > the LED2 and you first need to configure it as INT.
>
> Do you plan to finish also this additional setup?

Yes as the MOCHAbin board that I have sent the DTS for also has it connected
so I can use it as Armada 7040 supports level triggers, unlike the A3720.
It's in the queue but as a low priority, so I don't know when will I get to it.

Regards,
Robert
>
> > Signed-off-by: Robert Marko <robert.marko@sartura.hr>
> > ---
> > arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts | 4 ++++
> > 1 file changed, 4 insertions(+)
> >
> > diff --git a/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts b/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts
> > index 8a700afd0570..96855a10b4a0 100644
> > --- a/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts
> > +++ b/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts
> > @@ -118,12 +118,16 @@ &usb3 {
> > &mdio {
> > extphy: ethernet-phy@1 {
> > reg = <1>;
> > +
> > + reset-gpios = <&gpionb 2 GPIO_ACTIVE_LOW>;
> > };
> > };
> >
> > &switch0 {
> > reg = <3>;
> >
> > + reset-gpios = <&gpiosb 23 GPIO_ACTIVE_LOW>;
> > +
> > ports {
> > switch0port1: port@1 {
> > reg = <1>;
> > --
> > 2.31.1
> >



--
Robert Marko
Staff Embedded Linux Engineer
Sartura Ltd.
Lendavska ulica 16a
10000 Zagreb, Croatia
Email: robert.marko@sartura.hr
Web: www.sartura.hr

\
 
 \ /
  Last update: 2021-09-28 18:03    [W:0.071 / U:0.312 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site