Messages in this thread | | | From | Bartosz Golaszewski <> | Date | Mon, 23 Aug 2021 10:02:20 +0200 | Subject | Re: [PATCH V3 3/3] gpio: modepin: Add driver support for modepin GPIO controller |
| |
On Wed, Aug 18, 2021 at 10:11 AM Piyush Mehta <piyush.mehta@xilinx.com> wrote: > > This patch adds driver support for the zynqmp modepin GPIO controller. > GPIO modepin driver set and get the value and status of the PS_MODE pin, > based on device-tree pin configuration. These four mode pins are > configurable as input/output. The mode pin has a control register, which > have lower four-bits [0:3] are configurable as input/output, next four-bits > can be used for reading the data as input[4:7], and next setting the > output pin state output[8:11]. > > Signed-off-by: Piyush Mehta <piyush.mehta@xilinx.com> > Acked-by: Michal Simek <michal.simek@xilinx.com> > Reviewed-by: Linus Walleij <linus.walleij@linaro.org> > ---
Which tree should this go through?
Bart
| |