lkml.org 
[lkml]   [2021]   [Aug]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [RFC PATCH 00/15] create power sequencing subsystem
From
Date
Hi Dmitry,

> This is an RFC of the proposed power sequencer subsystem. This is a
> generification of the MMC pwrseq code. The subsystem tries to abstract
> the idea of complex power-up/power-down/reset of the devices.
>
> The primary set of devices that promted me to create this patchset is
> the Qualcomm BT+WiFi family of chips. They reside on serial+platform
> interfaces (older generations) or on serial+PCIe (newer generations).
> They require a set of external voltage regulators to be powered on and
> (some of them) have separate WiFi and Bluetooth enable GPIOs.
>
> This patchset being an RFC tries to demonstrate the approach, design and
> usage of the pwrseq subsystem. Following issues are present in the RFC
> at this moment but will be fixed later if the overall approach would be
> viewed as acceptable:
>
> - No documentation
> While the code tries to be self-documenting proper documentation
> would be required.
>
> - Minimal device tree bindings changes
> There are no proper updates for the DT bindings (thus neither Rob
> Herring nor devicetree are included in the To/Cc lists). The dt
> schema changes would be a part of v1.
>
> - Lack of proper PCIe integration
> At this moment support for PCIe is hacked up to be able to test the
> PCIe part of qca6390. Proper PCIe support would require automatically
> powering up the devices before the scan basing on the proper device
> structure in the device tree.
>
> ----------------------------------------------------------------
> Dmitry Baryshkov (15):
> power: add power sequencer subsystem
> pwrseq: port MMC's pwrseq drivers to new pwrseq subsystem
> mmc: core: switch to new pwrseq subsystem
> ath10k: add support for pwrseq sequencing
> Bluetooth: hci_qca: merge qca_power into qca_serdev
> Bluetooth: hci_qca: merge init paths
> Bluetooth: hci_qca: merge qca_power_on with qca_regulators_init
> Bluetooth: hci_qca: futher rework of power on/off handling
> Bluetooth: hci_qca: add support for pwrseq

any chance you can try to abandon patching hci_qca. The serdev support in hci_uart is rather hacking into old line discipline code and it is not aging well. It is really becoming a mess.

I would say that the Qualcomm serial devices could use a separate standalone serdev driver. A while I send an RFC for a new serdev driver.

https://www.spinics.net/lists/linux-bluetooth/msg74918.html

There I had the idea that simple vendor specifics can be in that driver (like the Broadcom part I added there), but frankly the QCA specifics are a bit too specific and it should be a separate driver. However I think this would be a good starting point.

In general a H:4 based Bluetooth driver is dead simple with the help of h4_recv.h helper we have in the kernel. The complicated part is the power management pieces or any vendor specific low-power protocol they are running on that serial line. And since you are touching this anyway, doing a driver from scratch might be lot simpler and cleaner. It would surely help all the new QCA device showing up in the future.

Regards

Marcel

\
 
 \ /
  Last update: 2021-08-19 17:24    [W:0.814 / U:0.316 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site