[lkml]   [2021]   [Jul]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Subject[PATCH v19 0/7] soc: mediatek: SVS: introduce MTK SVS
1. SVS driver uses OPP adjust event in [1] to update OPP table voltage part.
2. SVS driver gets thermal/GPU device by node [2][3] and CPU device by get_cpu_device().
After retrieving subsys device, SVS driver calls device_link_add() to make sure probe/suspend callback priority.
3. SVS dts refers to reset controller [4] to help reset SVS HW.

#mt8183 SVS related patches

#mt8192 SVS related patches

changes since v18:
- Add edge case handling in svs_set_freqs_pct_v3() when turn_pt is 0.
If we don't add this handling, SVS HIGH bank will fill FREQPCT74 / FREQPCT30 with 0 and SVS controller won't run normally.
- Remove redundant SVSB_MON_VOLT_IGNORE flag from svs_mt8192_banks[]'s low bank configuration.

Roger Lu (7):
[v19,1/7] dt-bindings: soc: mediatek: add mtk svs dt-bindings
[v19,2/7] arm64: dts: mt8183: add svs device information
[v19,3/7] soc: mediatek: SVS: introduce MTK SVS engine
[v19,4/7] soc: mediatek: SVS: add debug commands
[v19,5/7] dt-bindings: soc: mediatek: add mt8192 svs dt-bindings
[v19,6/7] arm64: dts: mt8192: add svs device information
[v19,7/7] soc: mediatek: SVS: add mt8192 SVS GPU driver

.../bindings/soc/mediatek/mtk-svs.yaml | 92 +
arch/arm64/boot/dts/mediatek/mt8183.dtsi | 15 +
arch/arm64/boot/dts/mediatek/mt8192.dtsi | 34 +
drivers/soc/mediatek/Kconfig | 10 +
drivers/soc/mediatek/Makefile | 1 +
drivers/soc/mediatek/mtk-svs.c | 2527 +++++++++++++++++
6 files changed, 2679 insertions(+)
create mode 100644 Documentation/devicetree/bindings/soc/mediatek/mtk-svs.yaml
create mode 100644 drivers/soc/mediatek/mtk-svs.c

 \ /
  Last update: 2021-07-02 05:12    [W:0.134 / U:0.108 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site