[lkml]   [2021]   [Jun]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v4 1/3] dt-bindings: pwm: Add Xilinx AXI Timer
On Fri, 28 May 2021 17:45:20 -0400, Sean Anderson wrote:
> This adds a binding for the Xilinx LogiCORE IP AXI Timer. This device is
> a "soft" block, so it has many parameters which would not be
> configurable in most hardware. This binding is usually automatically
> generated by Xilinx's tools, so the names and values of some properties
> must be kept as they are. Replacement properties have been provided for
> new device trees.
> Because we need to init timer devices so early in boot, the easiest way
> to configure things is to use a device tree property. For the moment
> this is 'xlnx,pwm', but this could be extended/renamed/etc. in the
> future if these is a need for a generic property.
> Signed-off-by: Sean Anderson <>
> ---
> Changes in v4:
> - Remove references to generate polarity so this can get merged
> - Predicate PWM driver on the presence of #pwm-cells
> - Make some properties optional for clocksource drivers
> Changes in v3:
> - Mark all boolean-as-int properties as deprecated
> - Add xlnx,pwm and xlnx,gen?-active-low properties.
> - Make newer replacement properties mutually-exclusive with what they
> replace
> - Add an example with non-deprecated properties only.
> Changes in v2:
> - Use 32-bit addresses for example binding
> .../bindings/pwm/xlnx,axi-timer.yaml | 85 +++++++++++++++++++
> 1 file changed, 85 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/pwm/xlnx,axi-timer.yaml

My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check'
on your patch (DT_CHECKER_FLAGS is new in v5.13):

yamllint warnings/errors:
./Documentation/devicetree/bindings/pwm/xlnx,axi-timer.yaml:16:10: [warning] wrong indentation: expected 10 but found 9 (indentation)
./Documentation/devicetree/bindings/pwm/xlnx,axi-timer.yaml:19:10: [warning] wrong indentation: expected 10 but found 9 (indentation)

dtschema/dtc warnings/errors:


This check can fail if there are any dependencies. The base for a patch
series is generally the most recent rc1.

If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to

pip3 install dtschema --upgrade

Please check and re-submit.

 \ /
  Last update: 2021-06-01 15:33    [W:1.400 / U:0.004 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site