lkml.org 
[lkml]   [2021]   [May]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [RESEND PATCH V4 3/8] arm64: dts: qcom: pm7325: Add pm7325 base dts file
On 2021-05-18 22:12, Matthias Kaehlcke wrote:
> On Tue, May 18, 2021 at 05:16:27PM +0530, Vinod Koul wrote:
>> On 18-05-21, 11:50, satya priya wrote:
>> > Add base DTS file for pm7325 along with GPIOs and temp-alarm nodes.
>> >
>> > Signed-off-by: satya priya <skakit@codeaurora.org>
>> > Reviewed-by: Matthias Kaehlcke <mka@chromium.org>
>> > ---
>> > Changes in RESEND V4:
>> > - No Changes.
>> >
>> > arch/arm64/boot/dts/qcom/pm7325.dtsi | 53 ++++++++++++++++++++++++++++++++++++
>> > 1 file changed, 53 insertions(+)
>> > create mode 100644 arch/arm64/boot/dts/qcom/pm7325.dtsi
>> >
>> > diff --git a/arch/arm64/boot/dts/qcom/pm7325.dtsi b/arch/arm64/boot/dts/qcom/pm7325.dtsi
>> > new file mode 100644
>> > index 0000000..e7f64a9
>> > --- /dev/null
>> > +++ b/arch/arm64/boot/dts/qcom/pm7325.dtsi
>> > @@ -0,0 +1,53 @@
>> > +// SPDX-License-Identifier: BSD-3-Clause
>> > +// Copyright (c) 2021, The Linux Foundation. All rights reserved.
>> > +
>> > +#include <dt-bindings/interrupt-controller/irq.h>
>> > +#include <dt-bindings/spmi/spmi.h>
>> > +
>> > +&spmi_bus {
>> > + pm7325: pmic@1 {
>> > + compatible = "qcom,pm7325", "qcom,spmi-pmic";
>>
>> where is qcom,pm7325 documented?

>
> good point, I missed that one.
>

Actually this point was discussed during V2(
https://lore.kernel.org/patchwork/patch/1406186/#1607321 ).
As far as I understand it is not mandatory to add "qcom,pm7325" as we
are adding "qcom,spmi-pmic". It is just a good to have change.
I could not find the documentation for pm8350c, pmk8350 and pmr735a as
well.

>> > + reg = <0x1 SPMI_USID>;
>> > + #address-cells = <1>;
>> > + #size-cells = <0>;
>> > +
>> > + pm7325_temp_alarm: temp-alarm@a00 {
>> > + compatible = "qcom,spmi-temp-alarm";
>> > + reg = <0xa00>;
>> > + interrupts = <0x1 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
>> > + #thermal-sensor-cells = <0>;
>> > + };
>> > +
>> > + pm7325_gpios: gpios@8800 {
>> > + compatible = "qcom,pm7325-gpio", "qcom,spmi-gpio";
>>
>> where is qcom,pm7325-gpio documented?
>
> It's added by the 'Add GPIO support for PM7325' series
> (https://patchwork.kernel.org/project/linux-arm-msm/list/?series=481133)
>
> The binding change was acked by Rob and the code by Bjorn, so it can be
> expected to land, but it would still be good to mention the dependency
> explicitly.

The binding patch is applied now.

Thanks,
Satya Priya

\
 
 \ /
  Last update: 2021-05-20 08:33    [W:0.076 / U:0.092 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site