lkml.org 
[lkml]   [2021]   [Apr]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 08/79] media: marvel-ccic: fix some issues when getting pm_runtime
Date
Calling pm_runtime_get_sync() is bad, since even when it
returns an error, pm_runtime_put*() should be called.
So, use instead pm_runtime_resume_and_get().

While here, ensure that the error condition will be checked
during clock enable an media open() calls.

Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@kernel.org>
---
drivers/media/platform/marvell-ccic/mcam-core.c | 9 +++++++--
1 file changed, 7 insertions(+), 2 deletions(-)

diff --git a/drivers/media/platform/marvell-ccic/mcam-core.c b/drivers/media/platform/marvell-ccic/mcam-core.c
index 141bf5d97a04..ea87110d9073 100644
--- a/drivers/media/platform/marvell-ccic/mcam-core.c
+++ b/drivers/media/platform/marvell-ccic/mcam-core.c
@@ -918,6 +918,7 @@ static int mclk_enable(struct clk_hw *hw)
struct mcam_camera *cam = container_of(hw, struct mcam_camera, mclk_hw);
int mclk_src;
int mclk_div;
+ int ret;

/*
* Clock the sensor appropriately. Controller clock should
@@ -931,7 +932,9 @@ static int mclk_enable(struct clk_hw *hw)
mclk_div = 2;
}

- pm_runtime_get_sync(cam->dev);
+ ret = pm_runtime_resume_and_get(cam->dev);
+ if (ret < 0)
+ return ret;
clk_enable(cam->clk[0]);
mcam_reg_write(cam, REG_CLKCTRL, (mclk_src << 29) | mclk_div);
mcam_ctlr_power_up(cam);
@@ -1611,7 +1614,9 @@ static int mcam_v4l_open(struct file *filp)
ret = sensor_call(cam, core, s_power, 1);
if (ret)
goto out;
- pm_runtime_get_sync(cam->dev);
+ ret = pm_runtime_resume_and_get(cam->dev);
+ if (ret < 0)
+ goto out;
__mcam_cam_reset(cam);
mcam_set_config_needed(cam, 1);
}
--
2.30.2
\
 
 \ /
  Last update: 2021-04-27 12:14    [W:0.239 / U:2.340 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site