lkml.org 
[lkml]   [2021]   [Mar]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH net-next v3] net: Add Qcom WWAN control driver
From
Date
On 3/9/2021 3:33 AM, Greg KH wrote:
> On Tue, Mar 09, 2021 at 11:28:49AM +0100, Loic Poulain wrote:
>> Hi Greg,
>>
>> On Tue, 9 Mar 2021 at 10:35, Greg KH <gregkh@linuxfoundation.org> wrote:
>>>
>>> On Tue, Mar 09, 2021 at 09:42:16AM +0100, Loic Poulain wrote:
>>>> The MHI WWWAN control driver allows MHI Qcom based modems to expose
>>>> different modem control protocols/ports to userspace, so that userspace
>>>> modem tools or daemon (e.g. ModemManager) can control WWAN config
>>>> and state (APN config, SMS, provider selection...). A Qcom based
>>>> modem can expose one or several of the following protocols:
>>>> - AT: Well known AT commands interactive protocol (microcom, minicom...)
>>>> - MBIM: Mobile Broadband Interface Model (libmbim, mbimcli)
>>>> - QMI: Qcom MSM/Modem Interface (libqmi, qmicli)
>>>> - QCDM: Qcom Modem diagnostic interface (libqcdm)
>>>> - FIREHOSE: XML-based protocol for Modem firmware management
>>>> (qmi-firmware-update)
>>>>
>>>> The different interfaces are exposed as character devices, in the same
>>>> way as for USB modem variants (known as modem 'ports').
>>>>
>>>> Note that this patch is mostly a rework of the earlier MHI UCI
>>>> tentative that was a generic interface for accessing MHI bus from
>>>> userspace. As suggested, this new version is WWAN specific and is
>>>> dedicated to only expose channels used for controlling a modem, and
>>>> for which related opensource user support exist. Other MHI channels
>>>> not fitting the requirements will request either to be plugged to
>>>> the right Linux subsystem (when available) or to be discussed as a
>>>> new MHI driver (e.g AI accelerator, WiFi debug channels, etc...).
>>>>
>>>> This change introduces a new drivers/net/wwan directory, aiming to
>>>> be the common place for WWAN drivers.
>>>>
>>>> Co-developed-by: Hemant Kumar <hemantk@codeaurora.org>
>>>> Signed-off-by: Hemant Kumar <hemantk@codeaurora.org>
>>>> Signed-off-by: Loic Poulain <loic.poulain@linaro.org>
>>>> ---
>>>> v2: update copyright (2021)
>>>> v3: Move driver to dedicated drivers/net/wwan directory
>>>>
>>>> drivers/net/Kconfig | 2 +
>>>> drivers/net/Makefile | 1 +
>>>> drivers/net/wwan/Kconfig | 26 ++
>>>> drivers/net/wwan/Makefile | 6 +
>>>> drivers/net/wwan/mhi_wwan_ctrl.c | 559 +++++++++++++++++++++++++++++++++++++++
>>>> 5 files changed, 594 insertions(+)
>>>> create mode 100644 drivers/net/wwan/Kconfig
>>>> create mode 100644 drivers/net/wwan/Makefile
>>>> create mode 100644 drivers/net/wwan/mhi_wwan_ctrl.c
>>>>
>>>> diff --git a/drivers/net/Kconfig b/drivers/net/Kconfig
>>>> index 1ebb4b9..28b18f2 100644
>>>> --- a/drivers/net/Kconfig
>>>> +++ b/drivers/net/Kconfig
>>>> @@ -501,6 +501,8 @@ source "drivers/net/wan/Kconfig"
>>>>
>>>> source "drivers/net/ieee802154/Kconfig"
>>>>
>>>> +source "drivers/net/wwan/Kconfig"
>>>> +
>>>> config XEN_NETDEV_FRONTEND
>>>> tristate "Xen network device frontend driver"
>>>> depends on XEN
>>>> diff --git a/drivers/net/Makefile b/drivers/net/Makefile
>>>> index f4990ff..5da6424 100644
>>>> --- a/drivers/net/Makefile
>>>> +++ b/drivers/net/Makefile
>>>> @@ -68,6 +68,7 @@ obj-$(CONFIG_SUNGEM_PHY) += sungem_phy.o
>>>> obj-$(CONFIG_WAN) += wan/
>>>> obj-$(CONFIG_WLAN) += wireless/
>>>> obj-$(CONFIG_IEEE802154) += ieee802154/
>>>> +obj-$(CONFIG_WWAN) += wwan/
>>>>
>>>> obj-$(CONFIG_VMXNET3) += vmxnet3/
>>>> obj-$(CONFIG_XEN_NETDEV_FRONTEND) += xen-netfront.o
>>>> diff --git a/drivers/net/wwan/Kconfig b/drivers/net/wwan/Kconfig
>>>> new file mode 100644
>>>> index 0000000..643aa10
>>>> --- /dev/null
>>>> +++ b/drivers/net/wwan/Kconfig
>>>> @@ -0,0 +1,26 @@
>>>> +# SPDX-License-Identifier: GPL-2.0-only
>>>> +#
>>>> +# Wireless WAN device configuration
>>>> +#
>>>> +
>>>> +menuconfig WWAN
>>>> + bool "Wireless WAN"
>>>> + help
>>>> + This section contains Wireless WAN driver configurations.
>>>> +
>>>> +if WWAN
>>>> +
>>>> +config MHI_WWAN_CTRL
>>>> + tristate "MHI WWAN control driver for QCOM based PCIe modems"
>>>> + depends on MHI_BUS
>>>> + help
>>>> + MHI WWAN CTRL allow QCOM based PCIe modems to expose different modem
>>>> + control protocols/ports to userspace, including AT, MBIM, QMI, DIAG
>>>> + and FIREHOSE. These protocols can be accessed directly from userspace
>>>> + (e.g. AT commands) or via libraries/tools (e.g. libmbim, libqmi,
>>>> + libqcdm...).
>>>> +
>>>> + To compile this driver as a module, choose M here: the module will be
>>>> + called mhi_wwan_ctrl.
>>>> +
>>>> +endif # WWAN
>>>> diff --git a/drivers/net/wwan/Makefile b/drivers/net/wwan/Makefile
>>>> new file mode 100644
>>>> index 0000000..994a80b
>>>> --- /dev/null
>>>> +++ b/drivers/net/wwan/Makefile
>>>> @@ -0,0 +1,6 @@
>>>> +# SPDX-License-Identifier: GPL-2.0
>>>> +#
>>>> +# Makefile for the Linux WWAN device drivers.
>>>> +#
>>>> +
>>>> +obj-$(CONFIG_MHI_WWAN_CTRL) += mhi_wwan_ctrl.o
>>>> diff --git a/drivers/net/wwan/mhi_wwan_ctrl.c b/drivers/net/wwan/mhi_wwan_ctrl.c
>>>> new file mode 100644
>>>> index 0000000..3904cd0
>>>> --- /dev/null
>>>> +++ b/drivers/net/wwan/mhi_wwan_ctrl.c
>>>> @@ -0,0 +1,559 @@
>>>> +// SPDX-License-Identifier: GPL-2.0-only
>>>> +/* Copyright (c) 2018-2021, The Linux Foundation. All rights reserved.*/
>>>> +
>>>> +#include <linux/kernel.h>
>>>> +#include <linux/mhi.h>
>>>> +#include <linux/mod_devicetable.h>
>>>> +#include <linux/module.h>
>>>> +#include <linux/poll.h>
>>>> +
>>>> +#define MHI_WWAN_CTRL_DRIVER_NAME "mhi_wwan_ctrl"
>>>
>>> So a driver name is the same as the class that is being created?
>>>
>>> That feels wrong, shouldn't the "class" be wwan?
>>
>> The driver does not aim to be THE wwan implementation, given the
>> heterogeneity of WWAN interfaces, so 'wwan' is probably too generic
>> for this bus/vendor specific driver. But since we create a new wwan
>> subdir, maybe we should create a minimal wwan_sysfs.c, that would
>> initially just offer a common class for all WWAN devices (wwan or
>> wwan-ports), as a first step to if not standardize, at least group
>> such devices under the same hat. Otherwise, we can just use the misc
>> class... Any thoughts?
>
> Why isn't this a good api for all wwan devices? Do you think that this
> will not work for others?
>
> A common class would be good, if they all work the same with regards to
> a user/kernel api, otherwise it's pointless and not needed :)
>
> And if we are back to the "custom user/kernel api just for this one
> driver", then yes, the misc api is the easiest and simplest to use, but
> I would wish for better than that for the first wwan driver...

I'm thinking this doesn't fit with the misc api due to the number of
device minors that could be expected to be consumed.

Each device supported by this driver is going to create 2-5 chardevs.
Having two devices in a system is common for "endusers". Development,
manufacturing, and test (including the community, not just talking
Qualcomm here) commonly have 12+ of these devices in a system. 12 * 5 =
60. Thats a lot of misc minor numbers to chew up just from one driver
given that the limit of dynamic minors is 128. Looking at a random x86
server that I have which could be used for such a usecase already has 30
misc minor numbers used, and this particular server has a fresh distro
install on it. I would expect that number to go up as it gets
provisioned for use.

I guess, the question to you is, how many misc minor numbers is "too
much" for a single driver to expect to consume?

--
Jeffrey Hugo
Qualcomm Technologies, Inc. is a member of the
Code Aurora Forum, a Linux Foundation Collaborative Project.

\
 
 \ /
  Last update: 2021-03-09 17:03    [W:0.070 / U:1.128 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site