lkml.org 
[lkml]   [2021]   [Feb]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v7 net-next 04/15] net: mvpp2: add PPv23 version definition
Hi,

wt., 2 lut 2021 o 09:17 <stefanc@marvell.com> napisał(a):
>
> From: Stefan Chulski <stefanc@marvell.com>
>
> This patch add PPv23 version definition.
> PPv23 is new packet processor in CP115.
> Everything that supported by PPv22, also supported by PPv23.
> No functional changes in this stage.
>
> Signed-off-by: Stefan Chulski <stefanc@marvell.com>
> ---
> drivers/net/ethernet/marvell/mvpp2/mvpp2.h | 24 ++++++++++++--------
> drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c | 17 +++++++++-----
> 2 files changed, 25 insertions(+), 16 deletions(-)
>
> diff --git a/drivers/net/ethernet/marvell/mvpp2/mvpp2.h b/drivers/net/ethernet/marvell/mvpp2/mvpp2.h
> index aec9179..89b3ede 100644
> --- a/drivers/net/ethernet/marvell/mvpp2/mvpp2.h
> +++ b/drivers/net/ethernet/marvell/mvpp2/mvpp2.h
> @@ -60,6 +60,9 @@
> /* Top Registers */
> #define MVPP2_MH_REG(port) (0x5040 + 4 * (port))
> #define MVPP2_DSA_EXTENDED BIT(5)
> +#define MVPP2_VER_ID_REG 0x50b0
> +#define MVPP2_VER_PP22 0x10
> +#define MVPP2_VER_PP23 0x11
>
> /* Parser Registers */
> #define MVPP2_PRS_INIT_LOOKUP_REG 0x1000
> @@ -469,7 +472,7 @@
> #define MVPP22_GMAC_INT_SUM_MASK_LINK_STAT BIT(1)
> #define MVPP22_GMAC_INT_SUM_MASK_PTP BIT(2)
>
> -/* Per-port XGMAC registers. PPv2.2 only, only for GOP port 0,
> +/* Per-port XGMAC registers. PPv2.2 and PPv2.3, only for GOP port 0,
> * relative to port->base.
> */
> #define MVPP22_XLG_CTRL0_REG 0x100
> @@ -506,7 +509,7 @@
> #define MVPP22_XLG_CTRL4_MACMODSELECT_GMAC BIT(12)
> #define MVPP22_XLG_CTRL4_EN_IDLE_CHECK BIT(14)
>
> -/* SMI registers. PPv2.2 only, relative to priv->iface_base. */
> +/* SMI registers. PPv2.2 and PPv2.3, relative to priv->iface_base. */
> #define MVPP22_SMI_MISC_CFG_REG 0x1204
> #define MVPP22_SMI_POLLING_EN BIT(10)
>
> @@ -582,7 +585,7 @@
> #define MVPP2_QUEUE_NEXT_DESC(q, index) \
> (((index) < (q)->last_desc) ? ((index) + 1) : 0)
>
> -/* XPCS registers. PPv2.2 only */
> +/* XPCS registers.PPv2.2 and PPv2.3 */
> #define MVPP22_MPCS_BASE(port) (0x7000 + (port) * 0x1000)
> #define MVPP22_MPCS_CTRL 0x14
> #define MVPP22_MPCS_CTRL_FWD_ERR_CONN BIT(10)
> @@ -593,7 +596,7 @@
> #define MVPP22_MPCS_CLK_RESET_DIV_RATIO(n) ((n) << 4)
> #define MVPP22_MPCS_CLK_RESET_DIV_SET BIT(11)
>
> -/* XPCS registers. PPv2.2 only */
> +/* XPCS registers. PPv2.2 and PPv2.3 */
> #define MVPP22_XPCS_BASE(port) (0x7400 + (port) * 0x1000)
> #define MVPP22_XPCS_CFG0 0x0
> #define MVPP22_XPCS_CFG0_RESET_DIS BIT(0)
> @@ -930,15 +933,16 @@ struct mvpp2 {
> void __iomem *iface_base;
> void __iomem *cm3_base;
>
> - /* On PPv2.2, each "software thread" can access the base
> + /* On PPv2.2 and PPv2.3, each "software thread" can access the base
> * register through a separate address space, each 64 KB apart
> * from each other. Typically, such address spaces will be
> * used per CPU.
> */
> void __iomem *swth_base[MVPP2_MAX_THREADS];
>
> - /* On PPv2.2, some port control registers are located into the system
> - * controller space. These registers are accessible through a regmap.
> + /* On PPv2.2 and PPv2.3, some port control registers are located into
> + * the system controller space. These registers are accessible
> + * through a regmap.
> */
> struct regmap *sysctrl_base;
>
> @@ -980,7 +984,7 @@ struct mvpp2 {
> u32 tclk;
>
> /* HW version */
> - enum { MVPP21, MVPP22 } hw_version;
> + enum { MVPP21, MVPP22, MVPP23 } hw_version;
>
> /* Maximum number of RXQs per port */
> unsigned int max_port_rxqs;
> @@ -1227,7 +1231,7 @@ struct mvpp21_rx_desc {
> __le32 reserved8;
> };
>
> -/* HW TX descriptor for PPv2.2 */
> +/* HW TX descriptor for PPv2.2 and PPv2.3 */
> struct mvpp22_tx_desc {
> __le32 command;
> u8 packet_offset;
> @@ -1239,7 +1243,7 @@ struct mvpp22_tx_desc {
> __le64 buf_cookie_misc;
> };
>
> -/* HW RX descriptor for PPv2.2 */
> +/* HW RX descriptor for PPv2.2 and PPv2.3 */
> struct mvpp22_rx_desc {
> __le32 status;
> __le16 reserved1;
> diff --git a/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c b/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
> index 307f9fd..11c56d2 100644
> --- a/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
> +++ b/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
> @@ -385,7 +385,7 @@ static int mvpp2_bm_pool_create(struct device *dev, struct mvpp2 *priv,
> if (!IS_ALIGNED(size, 16))
> return -EINVAL;
>
> - /* PPv2.1 needs 8 bytes per buffer pointer, PPv2.2 needs 16
> + /* PPv2.1 needs 8 bytes per buffer pointer, PPv2.2 and PPv2.3 needs 16

s/needs 16/need 16/

> * bytes per buffer pointer
> */
> if (priv->hw_version == MVPP21)
> @@ -1173,7 +1173,7 @@ static void mvpp2_interrupts_unmask(void *arg)
> u32 val;
> int i;
>
> - if (port->priv->hw_version != MVPP22)
> + if (port->priv->hw_version == MVPP21)
> return;

This change should go to "net: mvpp2: always compare hw-version vs
MVPP21" patch. Please also swap order of those 2 commits - the
preparation patch should go before MVPP23 addition.

Thanks,
Marcin

\
 
 \ /
  Last update: 2021-02-04 20:04    [W:0.119 / U:1.572 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site