lkml.org 
[lkml]   [2021]   [Feb]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH V3] drivers: net: ethernet: i825xx: Fix couple of spellings in the file ether1.c
Date


s/initialsation/initialisation/
s/specifiing/specifying/

Signed-off-by: Bhaskar Chowdhury <unixbhaskar@gmail.com>
---
Changes from V2:
Adjust and make changes which are obvious as per Randy's suggestions

drivers/net/ethernet/i825xx/ether1.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/net/ethernet/i825xx/ether1.c b/drivers/net/ethernet/i825xx/ether1.c
index a0bfb509e002..c612ef526d16 100644
--- a/drivers/net/ethernet/i825xx/ether1.c
+++ b/drivers/net/ethernet/i825xx/ether1.c
@@ -20,7 +20,7 @@
* 1.02 RMK 25/05/1997 Added code to restart RU if it goes not ready
* 1.03 RMK 14/09/1997 Cleaned up the handling of a reset during the TX interrupt.
* Should prevent lockup.
- * 1.04 RMK 17/09/1997 Added more info when initialsation of chip goes wrong.
+ * 1.04 RMK 17/09/1997 Added more info when initialisation of chip goes wrong.
* TDR now only reports failure when chip reports non-zero
* TDR time-distance.
* 1.05 RMK 31/12/1997 Removed calls to dev_tint for 2.1
@@ -117,7 +117,7 @@ ether1_outw_p (struct net_device *dev, unsigned short val, int addr, int svflgs)
* Some inline assembler to allow fast transfers on to/off of the card.
* Since this driver depends on some features presented by the ARM
* specific architecture, and that you can't configure this driver
- * without specifiing ARM mode, this is not a problem.
+ * without specifying ARM mode, this is not a problem.
*
* This routine is essentially an optimised memcpy from the card's
* onboard RAM to kernel memory.
--
2.26.2
\
 
 \ /
  Last update: 2021-02-04 04:18    [W:0.067 / U:0.076 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site