[lkml]   [2021]   [Feb]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH] USB: serial: cp210x: Make the CP210x driver work with GPIOs
On Tue, Feb 23, 2021 at 10:02:08AM +0000, Pho Tran wrote:
> Similar to other CP210x devices, GPIO interfaces (gpiochip) should be supported for CP2108.
> CP2108 has 4 serial interfaces but only 1 set of GPIO pins are shared to all of those interfaces.
> So, just need to initialize GPIOs of CP2108 with only one interface (I use interface 0).
> It means just only 1 gpiochip device file will be created for CP2108.
> CP2108 has 16 GPIOs, So data types of several variables need to be is u16
> instead of u8(in struct cp210x_serial_private). This doesn't affect other CP210x devices.
> Because CP2108 has 16 GPIO pins, the parameter which is passed by CP210x functions
> will be different from other CP210x devices. So need to check part number of the device
> to use correct data format before sending commands to devices.
> Like CP2104, CP2108 have GPIO pins with configurable options. Therefore, in cp2108_gpio_init() function,
> Should be mask all pins which are not in GPIO mode.
> Signed-off-by: Pho Tran <<>>
> ---
> drivers/usb/serial/cp210x.c | 199 +++++++++++++++++++++++++++++++-----
> 1 file changed, 172 insertions(+), 27 deletions(-)

You sent this patch twice, and I'm afraid both have been white-space
corrupted (e.g. by your mailer).

Try sending the patch to yourself first and make sure you can apply it
using git-am (and run on it without any obvious errors).


 \ /
  Last update: 2021-02-23 11:16    [W:0.023 / U:3.628 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site