[lkml]   [2021]   [Feb]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Patch in this message
Subject[PATCHv1 1/6] rtc: m41t80: add support for protected clock
Congatec's QMX6 system on module (SoM) uses a m41t62 as RTC. The
modules SQW clock output defaults to 32768 Hz. This behaviour is
used to provide the i.MX6 CKIL clock. Once the RTC driver is probed,
the clock is disabled and all i.MX6 functionality depending on
the 32 KHz clock has undefined behaviour. On systems using hardware
watchdog it seems to likely trigger a lot earlier than configured.

The proper solution would be to describe this dependency in DT,
but that will result in a deadlock. The kernel will see, that
i.MX6 system clock needs the RTC clock and do probe deferral.
But the i.MX6 I2C module never becomes usable without the i.MX6
CKIL clock and thus the RTC's clock will not be probed. So from
the kernel's perspective this is a chicken-and-egg problem.

Technically everything is fine by not touching anything, since
the RTC clock correctly enables the clock on reset (i.e. on
battery backup power loss) and also the bootloader enables it
in case a kernel without this support has been booted.

The 'protected-clocks' property is already in use for some clocks
that may not be touched because of firmware limitations and is
described in Documentation/devicetree/bindings/clock/clock-bindings.txt.

Signed-off-by: Sebastian Reichel <>
Documentation/devicetree/bindings/rtc/rtc-m41t80.txt | 1 +
drivers/rtc/rtc-m41t80.c | 3 +++
2 files changed, 4 insertions(+)

diff --git a/Documentation/devicetree/bindings/rtc/rtc-m41t80.txt b/Documentation/devicetree/bindings/rtc/rtc-m41t80.txt
index c746cb221210..ea4bbf5c4282 100644
--- a/Documentation/devicetree/bindings/rtc/rtc-m41t80.txt
+++ b/Documentation/devicetree/bindings/rtc/rtc-m41t80.txt
@@ -19,6 +19,7 @@ Optional properties:
- interrupts: rtc alarm interrupt.
- clock-output-names: From common clock binding to override the default output
clock name
+- protected-clocks: Bool, if set operating system should not handle clock.
- wakeup-source: Enables wake up of host system on alarm

diff --git a/drivers/rtc/rtc-m41t80.c b/drivers/rtc/rtc-m41t80.c
index 160dcf68e64e..3296583853a8 100644
--- a/drivers/rtc/rtc-m41t80.c
+++ b/drivers/rtc/rtc-m41t80.c
@@ -546,6 +546,9 @@ static struct clk *m41t80_sqw_register_clk(struct m41t80_data *m41t80)
struct clk_init_data init;
int ret;

+ if (of_property_read_bool(node, "protected-clocks"))
+ return 0;
/* First disable the clock */
ret = i2c_smbus_read_byte_data(client, M41T80_REG_ALARM_MON);
if (ret < 0)
 \ /
  Last update: 2021-02-22 18:15    [W:0.144 / U:0.052 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site