lkml.org 
[lkml]   [2021]   [Feb]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 02/13] serial: stm32: fix startup by enabling usart for reception
Date
RX is configured, but usart is not enabled in startup function.
Kernel documentation specifies that startup should enable the port for
reception.
Fix the startup by enabling usart for reception.

Fixes: 84872dc448fe ("serial: stm32: add RX and TX FIFO flush")
Signed-off-by: Erwan Le Ray <erwan.leray@foss.st.com>

diff --git a/drivers/tty/serial/stm32-usart.c b/drivers/tty/serial/stm32-usart.c
index c67029ebcac8..33a479062948 100644
--- a/drivers/tty/serial/stm32-usart.c
+++ b/drivers/tty/serial/stm32-usart.c
@@ -634,6 +634,7 @@ static int stm32_usart_startup(struct uart_port *port)
{
struct stm32_port *stm32_port = to_stm32_port(port);
struct stm32_usart_offsets *ofs = &stm32_port->info->ofs;
+ struct stm32_usart_config *cfg = &stm32_port->info->cfg;
const char *name = to_platform_device(port->dev)->name;
u32 val;
int ret;
@@ -658,7 +659,7 @@ static int stm32_usart_startup(struct uart_port *port)
}

/* RX FIFO enabling */
- val = stm32_port->cr1_irq | USART_CR1_RE;
+ val = stm32_port->cr1_irq | USART_CR1_RE | BIT(cfg->uart_enable_bit);
if (stm32_port->fifoen)
val |= USART_CR1_FIFOEN;
stm32_usart_set_bits(port, ofs->cr1, val);
--
2.17.1
\
 
 \ /
  Last update: 2021-02-19 18:50    [W:0.283 / U:1.544 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site