lkml.org 
[lkml]   [2021]   [Oct]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH] spi: bcm2835: do not unregister controller in shutdown handler
From
Date
On 10/4/21 9:51 AM, Jason Gunthorpe wrote:
> On Mon, Oct 04, 2021 at 09:36:37AM -0700, Florian Fainelli wrote:
>
>> No please don't, I should have arguably justified the reasons why
>> better, but the main reason is that one of the platforms on which this
>> driver is used has received extensive power management analysis and
>> changes, and shutting down every bit of hardware, including something as
>> small as a SPI controller, and its clock (and its PLL) helped meet
>> stringent power targets.
>
> Huh? for device shutdown? What would this matter if the next step is
> reboot or power off?

Power off, the device is put into a low power state (equivalent to ACPI
S5) and then a remote control key press, or a GPIO could wake-up the
device again. While it is in that mode, it consumes less than 0.5W(AC).
Imagine your stick/cast/broom behind your TV falling in that category.

>
>> TBH, I still wonder why we have .shutdown() and we simply don't use
>> .remove() which would reduce the amount of work that people have to do
>> validate that the hardware is put in a low power state and would also
>> reduce the amount of burden on the various subsystems.
>
> The difference between remove and shutdown really is that 'emergency'
> sense that shutdown is something that must complete in bounded time
> and thus only has to concern itself with quieting hardware to a safe
> state for the next step in the shutdown/reboot/kexec/kdump sequence.

I am fairly sure that no driver write knows about the being bound in
time aspect.

>
> Many remove handlers happily block until, eg all user files are closed
> or something to allow a graceful module unload.

Fair point.
--
Florian

\
 
 \ /
  Last update: 2021-10-04 18:57    [W:0.061 / U:0.376 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site